DARNING
WITH
PRESSER
FOOT:
1,
2.
3.
4.
5_
Turn feed dog control
to left.
Press down
outer ring of presser foot knob, see page 10. With presser foot knob in this'position, mending,
darning,
monogram
work, etc. may be done.
Stretch
fabric
tightly
between
two
spring
embroidery
hoops
and
place
under
needle.
Lower
presser bar so thread willhave
some tension.
When you start to darn, move fabric back and forth to
cover darning
area. Then turn fabric and continue
sewing at right angles to the previous stitching.
Use medium
machine
speed. You can make any length stitches desired.
Slow movement of fabric will make short darning
stitches.
Fast movement
will make long stitches.
When you finish darning, raise presser foot and remove fabric. Increase pressure for general sewing by pressing
down
inner pin of the presser foot knob. Turn feed dog control to right.
WITHOUT
PRESSER
FOOT :
1. Turn
feed
dog
control
to left.
2.
Remove
presser
foot.
Proceed
as directed
under
steps
3 and
4 above.
3. When
you
finish
darning,
raise
the
presser
foot
lever
and
remove
fabric.
Replace
presser
foot,
and
increase
pressure
for
general
sewing.
Turn
feed
dog
control
to right.
18