Advertisement
To select a pile height setting:
Turn off cleaner. Select a pile height setting
by tilting the cleaner back until front wheels
are lifted slightly off the floor as illustrated°
Slide the adjustment
lever to the correct
setting°
SUGGESTED
PILE HEIGHT SETTINGS
You may need to raise the height to make
some jobs easier, such as scatter rugs and
longer pile carpets.
Suggested
settings are:
HIGH: shag carpet, long pile, plush, scatter
rugs.
MED: medium to long pileo
LOW: short to medium pile.
EX LOW: very low pile,
SOME MODELS
WARNING
Personal
Injury Hazard
DO NOT place hands or feet
underneath
the unit when chang-
ing from the bare floor
to the car-
pet pile height setting, The agita-
tor begins to revolve rapidly when
the vacuum
is turned on and is in
the carpet setting.
Bare floor
setting:
Slide the carpet/bare
floor selector
all the way back and down
toward the bottom of the nozzle until it locks
into place°
In this position the brush assembly
does not
revolve° This setting should be used
for
cleaning
hardwood
and tile floors and when
any attachments
(tools)
are used_
Carpet setting:
Slide the selector
all the
way forward
and up to the carpet
position.
In this position the brush assembly
will turn,.
When carpets are being cleaned the selec-
tor should be in this position°
Attention:
Refer to your carpet manufac-
turers cleaning
recommendations,
Some
more delicate carpets
may require that they
be vacuumed
with the agitator turned off, to
prevent carpet damage.
CAUTION
Do not allow vacuum cleaner to
remain in one spot for any length of
time when the agitator is turning.
Damage to carpet may occur.
NOTE:
For longer belt life, turn vacuum off
before moving selector.
Failure to do so can
cause the belt to rub on the selector shaft
and may result in the belt becoming
hot and
creating a burning
rubber smell
Carpet!Bare
Floor Selector
\
To Bare Floor
Position
To Carpet
Position
Advertisement
