Advertisement
!
WARNING ........................ I
Electrical
Shock Hazard
Do not plug into the electrical
sup-
ply until the assembly
is complete.
Failure to do so could result in elec-
trical shock or injury.
Before assembling
vacuum, check the
PACKING LIST on the cover of the separate
Repair Parts List° Use this list to verify that
you have received all the components
of
your new Kenmore vacuum,
Remove the tape located below the dust
cover/filter cover on the motor case,
Tape
Attach
stretch
hose end to
nozzle as
shown.
#
HANDLE ASSEMBLY
Remove the screw located just below the
top edge of the back of the vacuum.
Position the handle as shown in the illustra-
tion below.
Slide the handle into the opening at the top
of the vacuum
Handle
Handle
Insert the screw so it passes through
the
handle into the vacuum°
Begin to tighten the screw with your fingers.
It may be necessary
to adjust the handle
slightly.
Advertisement
