Changing Oven Light; Adjusting Oven Temperature; Avoid Service Checklist - Frigidaire Gallery Owner's Manual

Changing Oven Light
On some models an interior oven light will turn automatically when the oven door is opened. The
oven light may be turned on when the door is closed by using the oven light switch located on the
control panel.
On some models, the lamp is covered with a glass shield held in place by a wire holder.
THIS GLASS SHIELD MUST BE IN PLACE WHENEVER THE OVEN IS IN USE.
To replace the light bulb:
CAUTION: BE SURE THE OVEN IS COOL.
1. Turn the power off at the main source.
2. Wear a leather-faced glove for protection against possible broken glass.
3. Replace bulb with 40 watts appliance bulb only.
4. For models with glass shield, press holder on one side to release glass shield, change bulb and be sure to replace the
glass shield.
Adjusting Oven Temperature
For instructions on how to adjust the oven temperature refer to the timer section or the electronic oven control guide.
Avoid Service Checklist
Before you call for service, review this list. It may save you time and expense. The list includes common occurrences that are
not the result of defective workmanship or materials in this appliance.
OCCURRENCE
Oven Control Beeps and Displays -F1-
through -F10-.
-FS- is displayed.
Installation.
Entire oven does not operate.
POSSIBLE CAUSE/SOLUTION
Electronic control has detected a fault condition. Push CANCEL pad to clear the display and
stop the display from beeping. Reprogram the oven. If a fault reoccurs, record the fault
number, push the CANCEL pad and contact an authorized servicer.
The door was left open and controls set for self-cleaning cycle. Close the door and push both
upper and lower oven CANCEL pads.
Place oven rack in center of oven. Place a level on the oven rack. Contact installing agent if
rack and cabinet cutout flooring are not level.
Kitchen cabinet misalignment may make oven appear to be not level. Be sure cabinets are
square and level. Contact cabinet maker to correct problem.
When the oven is first plugged in, or when the power supply to the oven has been interrupted,
the display will flash. The oven cannot be programmed until the clock is set.
Be sure electrical cord is securely connected into the electrical junction box.
Cord/plug is not installed and/or connected. Cord is not supplied with oven. Contact your
dealer, installing agent or authorized servicer.
Service wiring not complete. Contact your dealer, installing agent or authorized servicer.
Power outage. Check house lights to be sure. Call your local electric company.
Short in cord/plug. Replace cord/plug.
Controls are not set properly. See instructions under Setting Oven Controls to set the
controls.
House fuse has blown or circuit breaker has tripped immediately following installation. House
fuse may not be fully engaged. Check fuse and screw or engage circuit breaker securely.
House fuse has blown or circuit breaker has tripped after the oven has been
installed and previously operating. Call an authorized servicer.
10