Manual Clock Setting; Tv Operation - JVC TV-13140 User Manual

MANUAL CLOCK SETTING TV OPERATION
You must set the date and time manually for timer recordings, ON/OFF Timer and Daylight Saving Time If
the AUto Clock process did not _ them correctly,
EXAMPLE: Setting the clock to _8:30 AM', 23th (SAT) October, 1999.
ill to se, thosYsTE.
SET-Up option, then press the ENTER button.
SET<-
-"(d_kTERMENU)
Press the SET + or - bulton to seleut the CLOCK
SET option, then press the ENTER button,
SET+
SET-
_ SET
i ST_VJ_ T_
press the SET + or - budcn
to set the month, then press
the ENTER button.
SET÷
Sat the day, year and time
as in stop 3.
SEt-+
After setting the clock, date an_ time"_
starts functioning automatically.
NOTE: • After a power lallure or disconnection of the power plug, the time display will be lost. In this case, set the
present grne again if the Auto Clock did not set correctly.
• If you want to conect the digits while setting, press the CANCEL button until the item you want to correct,
then press the SET+ or - buttonto correct the desired setting.
16
U TO tom on the TV/VCR,
press the POWER button.
Adjust tbe voiome leval by pressing the VOLUME + or -
button. The volume Level will
be indicated on the screen by green
bar. AS the volume level increases,
so do the number of ber_ If the
volume decreases, the number of
green bar also decreases.
Set the TV/CA'rV menu option to the appropriate
position. (See page 21 .)
[ CTVATV _ VHFL_I"FTvCChhaannnnt/_s I
VHF/UHF/CATV CHANNELS
1"/ CAW
VHF VHF
2-13 2-13
UHF STD/HRC/IRC
14-69 t4-36
(A) (W)
37-59
/(_'_'-.=J.,_ I I (_'_)=_ (zzz_I
95-99
(A-S)(A-l)
100-125
(SA)
_ Press the Direct Channel selec0orlbuttonsto select the channel.
W mode direct channel indention -
/
When the W/CAW menu option is in the TV position,ell channels can be instantlyselected by using two
buttons, (forexample, to select chan,lts2, pre_.s"0", then "2". If you press only "2",channelselection willbe delayed for/
a few seconds.) For channels 10 and above, press the 2 digitsin order. 0 1 2
When the TV/CATV menu optionis in the CAW portion, channels P.an be sts_t_d as to_iows:
TO SELECT CATV CHANNELS:
1-9 Press "0"twice, than 1-9 as needed. (Example, to select channel 2, press 002.)
10-12 Press "0",then the remaJning 2 digits. (Example, toselect channel t 2, press 012,)
100-125 Press the 3 digits in orbed, ( Example, to select channel 120, press 120.)
NOTE FOR CHANNELS 1-12:
If only 1 or 2 buttons are pressed, the corresponding channel will be selected in 2 seconds.
NOTE: • If a channel with no broadcast is selected, the sound will automatically be muted.
• If a station being viewed stops broadcasting, the "IV will automatically shut itself oft after 15 minutes.
17