Installation Instructions; Tools And Parts; Location Requirements; Electrical Requirements - Jenn-Air JUR248LBES00 Use & Care Manual

Table of Contents

Advertisement

Available languages

Available languages

INSTALLATION INSTRUCTIONS
TOOLS NEEDED:
Gather the required tools and parts before starting installation.
Phillips screwdriver
_>%,/%_
+,,,/
+ +_,,,/_
_ ,,>
Explosion
Hazard
Keep flammable
materials
and vapors, such as
gasoline,
away from refrigerator.
Failure to do so can result
in death, explosion, or fire.
To ensure proper ventilation for your refrigerator, allow for a %"
(6.35 mm) space on each side and at the top. When installing
your refrigerator next to a fixed wall, leave 2_/2 '' (6.35 cm)
minimum clearance on the hinge side to allow for the door to
swing open.
NOTE: It is recommended
that you do not install the refrigerator
near an oven, radiator, or other heat source. Do not install in a
location where the temperature will fall below 55°F (13°C). For
best performance,
do not install the refrigerator behind a cabinet
door or block the base grille.
I I
II
1/4' (6,35 mm)
ii
i/t
'U j
2V2"(6.35 era)
Electrical
Shock Hazard
Plug into a grounded
3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension
cord.
Failure to follow
these instructions can result in death,
fire, or electrical shock.
Before you move your refrigerator into its final location, it is
important to make sure you have the proper electrical
connection.
Recommended
grounding
method
A 115 Volt, 60 Hz., AC only 15- or 20-amp fused, grounded
electrical supply is required. It is recommended
that a separate
circuit serving only your refrigerator be provided. Use an outlet
that cannot be turned off by a switch. Do not use an
extension cord.
NOTE: Before performing any type of installation, cleaning, or
removing a light bulb, unplug refrigerator or disconnect
power.
Excessive Weight Hazard
Use two or more people to move and install
refrigerator.
Failure to do so can result in back or other injury.
Remove the Packaging
Remove tape and glue residue from surfaces before turning
on the refrigerator. Rub a small amount of liquid dish soap
over the adhesive with your fingers. Wipe with warm water
and dry.
Do not use sharp instruments,
rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your refrigerator. For
more information, see "Refrigerator
Safety."

Advertisement

Table of Contents
loading

This manual is also suitable for:

Jur248rbeb00Jur248lbeb00Jur248lyep00Jur248ryep00

Table of Contents