Cooktop Use; Dual/Triple Element; Keep Warm; All Off/Lock - Jenn-Air JED4430WB01 Use & Care Manual

COOKTOP USE
Fire Hazard
Turn off all controls when done cooking.
Failure to do so can result in death or fire.
Use the following chart as a guide when setting heat levels.
SETTING RECOMMENDED USE
High • Start food cooking.
10
• Bring liquid to a boil.
Medium High • Hold a rapid boil.
Between 7-9
• Quickly brown or sear food.
Med • Maintain a slow boil.
6 • Fry or saute foods.
The electronic touch controls offer a variety of heat settings for
optimal cooking results.
For maximum element operation, all cooktop electronic touch
controls can be set to High when bringing liquids to a rapid boil.
When the cooktop is turned On or after power is restored to the
cooktop after a power failure, all temperature setting lights will
glow for 10-15 seconds. After the lights go off, the cooktop is
ready to use.
............................
OFF
Medium Low • Cook soups, sauces and
3-5 gravies.
• Stew or steam food.
Low • Provide lowest simmer/heat
2 setting.
• Simmer (range of simmer
temperatures).
• Melt chocolate and butter.
Keep Warm • Keep cooked foods warm.
Dual/Triple Elements • Home canning.
• Large-diameter cookware.
• Large quantities of food.
A. Keep Warm light
To Use:
1. Touch the ON pad for the desired element. The Keep Warm
light will blink.
2. While the Keep Warm light is blinking, touch the desired
Power Level on the Power Level Selector Bar.
ALL OFF ON Keep Warm Low High
LOCK 1 ; :_ 4 s 6 7 s 9 0
O O
A beep will sound each time a pad is touched. The lights for
the selected temperature setting, and all lower temperatures,
will glow.
NOTE: If a power level setting is not selected within
approximately 10 seconds, the element will automatically
shut off.
3. To change the temperature setting while cooking, touch the
ON pad for the desired element, and select a new
temperature on the Power Level Selector Bar while the Keep
Warm light is blinking.
4. When finished cooking, touch OFF to turn off surface cooking
area(s) individually or ALL OFF/LOCK to turn off all surface
cooking areas at once.
I EMEMBER: When cooktop is in use, the entire cooktop
area may become hot.
Hot Surface Indicator Lights
The Hot Surface Indicator Lights are located next to each of the
cooktop controls. The Hot Surface Indicator Lights will glow as
long as any surface cooking area is too hot to touch, even after
the surface cooking area(s) is turned off.
I
%%
OFF
A. Hot surface indicator light
If the cooktop is on when a power failure occurs, the Hot Surface
Indicator Lights will remain on up to 45 minutes after the power is
restored to the cooktop.
Cooktop On Indicator Light
The Power Level Selector has a Cooktop On Indicator light.
When any of the elements are on, the light will glow.
The Keep Warm light next to an element will glow when that
element is on.