Hitachi DZ-GX5080A Instruction Manual page 140

Disc cannot be
removed.
(Cover will not open.)
• Did you detach the battery or AC adapter/charger before
24, 25, 29
Disc cover cannot be
closed. 36
24, 26
Operating sound is
heard cyclically.
Some vibrations are felt
or slight sound is heard
from mechanism.
• No operation can be
performed because
the ACCESS/PC or
CARD ACCESS
indicator on this DVD
video camera/
recorder remains lit or
blinking.
• After disc or card is
inserted, it takes
some time until
recording is possible.
No image in viewfinder.
setting the power switch to "OFF"?
Is the battery charged?
Connect a charged battery or the AC adapter/charger, and then
press the DISC EJECT button to remove the disc.
• Did the DVD video camera/recorder turn off because the
battery remaining level ran out?
Connect a charged battery or the AC adapter/charger, set the
power switch to "OFF", and then press the DISC EJECT button
to remove the disc.
Is disc correctly inserted?
Was disc inserted from wrong direction?
Remove the disc and then reinsert it.
Connect a fully charged battery or AC adapter/charger, and then
turn the DVD video camera/recorder on.
This sound is heard because the disc is cyclically operated and
does not indicate a fault.
These vibrations or sound are caused by disc drive: This does
not indicate a fault.
In the following cases, it will take more time than usual until
operation is possible:
• Immediately after a disc or card is reinserted.
• When a long time has elapsed since the DVD video camera/
recorder was turned off last.
• When the temperature is greatly different from the status of
previous recording.
• When disc with scratches, dirt or fingerprints is inserted.
• When disc is subject to severe vibrations.
• When the battery or DC power cord was disconnected instead
of following the correct procedure using power switch to turn
the DVD video camera/recorder off.
• Is LCD monitor open?
No image will appear in viewfinder unless the LCD monitor is
closed and securely locked to DVD video camera/recorder.
• Is the DVD video camera/recorder set to the sleep/restart
status?
Press the SLEEP/RESTART button to release the sleep/restart
status.
• Is DVD video camera/recorder connected to PC using PC
connection cable?
Unplug the PC connection cable.
• Does DVD video camera/recorder stop at the end of the scene
to which wipe-out was set and played back?
Press the DISC NAVIGATION button.
• Is the DVD video camera/recorder set to the sleep/restart
status?
Press the SLEEP/RESTART button to release the sleep/restart
status.
No image appears on
the LCD screen or in
the viewfinder.
7, 36
30,41
41,80,113
141