Download Print this page

Husqvarna GTH2548B Owner's Manual page 21

917.279040

Advertisement

SERVICE AND ADJUSTMENTS
WARNING: TO AVOID SERIOUS
iNJURY, BEFORE PERFORMING
ANY SERVICE OR ADJUST-
MENTS:
o
Depress brake pedal fully and set parking brake.
®
Place attachment
clutch
in "DISENGAGED"
position.
,
Turn ignition
key to"STOP"
and remove key.
,
Make sure the blades and aH moving parts have completely
stopped.
®
Disconnect spark plug wire from spark plug and place wire where it cannot come in contact
with plug.
TO REMOVE
MOWER
(See Fig. 18)
[&
PUaceattachment dutch in "DUSENGAGED" position,
If equipped,
turn height adjustment
knob to lowest
setting,
Lower mower to its lowest position,
Disengage belt tension rod from lock bracket,
CAUTION: Rod is spring loaded. Have a
1
tight grip on rod and retease slowly.
1
Remove retainer spring holding anti-swaybar to chassis
bracket and disengage anti-swaybar from bracket,
o
Remove four retainer springs from front plate assembly
and remove plate,
o
Remove retainer springs from suspension arms at deck
and disengage arms from deck,
o
Raise attachment lift to its highest position,
Slide mower forward and remove belt from electric
clutch pulley,
o
Slide mower out from under right side of tractor,
TO mNSTALL MOWER
Be sure tractor is on level surface and mower suspension
arms are raised with attachment lift control, Engage park°
[ng brake,
o
Swing anti-sway bar to left side of mower deck,
o
Slide mower under tractor with deflector shield to right
side of tractor,
_MPORTANT: CHECK BELT FOR PROPER ROUTING IN ALL
MOWER PULLEY GROOVES=
o
If equipped,
turn height adjustment
knob counter°
clockwise until it stops,
o
Lower mower linkage with attachment lift control,
o
Be sure belt tension rod is in disengaged position,
o
Install belt into electric clutch pulley groove,
o
Place the suspension arms on outward pointing deck
pins, Retain with double loop retainer spring with loops
up as shown,
Install front plate assembly
to tractor
suspension
brackets and retain with single loop retainer springs
as shown,
SUSPENSION
ARMS
/7
BELTTENSION
ROD "_._//"
(DISENGAGED
POSITION)
,,
//
LOCKBRACKET
FRONT
ELECTRIC
MOWER
CLUTCH
FRONT PLATE
BRACKET
PULLEY
--MBLY
BOUBLELOOP
SPRING
CHASSIS
BRACKET
SINGLE LOOP
RETAINER
SPRING
SPRING
USE PUERS FOR
RETAINER SPRINGS
LOOP UP
ANTFSWAY
BAR
SUSPENSION
ARMS
DOUBLE LOOP
RETAINER SPRINGS
(Outward
pointing
deck pins)
o
FIG. 18
21
FLANGED
PmN
DEFLECTOR

Advertisement

loading

This manual is also suitable for:

91.279040