Hotpoint HTM18IBPLRSA Owner's Manual And Installation Instructions page 21

Installation Instructions
[] TRANSFER BOTTOM HINGE
BRACKET TO THE LEFT
For' models with a base grille, remove it by gnLsping it
alxmt 6" iiom each end and pulling its bottom edge
towmd yOIl
Using a lbrx '_ driver; move the bottom hinge black,el
and plastic w;Lsh(;_ Ii'om tile light skle to tim left side
NOTE: II the washer is not on dw hinge bracket,
check to see iiit is stuck to tile bottom t:,[ tim dooc
q
[
Plastic Washer
,..I /
.4"
Hin ge Bra_"c@kelt'_ _iI__
For models
with a base grille, beibre
lcplacing tile
base gillie _emove the gillie cap by removing the
screw Sol ew the cap to the opposite side
Replace
file b&se gnille by insel dng die lops ol the
metal clips into die owll
vcqlls,
lil;'tldllg Slll÷e Oiie olthe
plastic tabs on the back of tile gillie goes iiltO each ol
the oven vents Then push the bottom of file _ille
lbrwm d until it. snaps into place
[] TRANSFER CENTER HINGE
BRACKET TO THE LEFT
Remove the center lfinge bracket by removing tile
t_ I I tle rolx
¢i_ sc lews
NOTE: Kee l) these screws wifll file binge bracket,
They are long soews and will be used when installing
dm hinge on the othm side
On some models, you will need m Iemove the color-
matched caps [iota die sclew ht;ads beibre you can
lelllOVe the sciews Use the edge ot a IJlill liar blade to
genii), PD' tim Calls 01t fire screw heads (A pull 7 knilL_
works well tbl this) Cove_ tile blade with tape to
1)xevent scratching the paint
Relllove tim thlee Tolx *_screws honl the celltei leli
side ol the cabinet. Screw them into the holes on
the light side.
Place tim centre hinge b,acket over the holes at
the ct.'nlet lell side o! the cabinel lnselt and
tighten the ilnee long sc_e\vs
Replace the caps by snapping them ovm the screws
with yore fingm
',0_%. ; Cap
[] TRANSFER DOOR STOPS
On each dooi; move the metal door stop lioru tilt:
fight to tile
left,
Move any screws Iionl the left to die right.
DoorSto
)
LeftSide RightSide
21