Hotpoint HTM18IBPLRSA Owner's Manual And Installation Instructions page 18

Installation Instructions
INSTALLING THE WATER LINE (CONT.)
i i ii i i iiii i i
[] CONNECT THE TUBING TO THE
REFRIGERATOR
NOTES:
Betble making the connection to tile lehigeiatol,
t)e sure the refrigelatol powel cold is not
plugged imo the wall outlet
We lecommend installing a watel filtm if yore
warm supply has sand or pailicles that could clog
the screett o[ tile leliigmalm's warm wflve Install
it ill the walm line ne;u the leliigelatm: If using
(,L Small(amn{{ t Reii igelator- "Ihbing kit, you
will need an additio,ml tube (¼rX08Xt0002) to
conne(I the fittm Do ItOl cut plastic tube to
install filter:
Renlove the sclews holding the zight side of the
access covet. Fold back tile covel:
Remove the plastic flexible cap
][i'Olll
the wa.tel valve
0etiigeratot connection)
Place tile conq)lesslon roll and
t_:nttlle (sleeve) omo the end ol
the tubing as showll On GFi
Sinai tC,onnecl '_' Refi igelalor
li,bing ldt, the nuts ale aheady
assembled to the tubing
©
Instal the end ol the tubing into the water valw_
connection as far as possible While holding tile
tubing, tighten tile fitting
For plastic tubing tiom a GE SmaxtConnect? _'
Refligelatol lubing kit, insert the molded end
of the tubing into the watm valve connection and
tigtuen complession nut until it is hand-tight;
then tighten one additional tulll with a wrench
Ove_ tightening may cause leaks
Fasten the tubing into tile clamp provided to hold
i! ill a velticat position, You may need to piy open
the chunp
[] CONNECT THE TUBING TO THE
REFRIGERATOR (CONT.)
One of the illustrations below will look like the
connection on yore' refrigerator.
Icemaker Models without Water Dispenser
1/4" Tubing
Tubing Clamp
Nut
(sleeve}
-Refrigerator
Tubing Connection
WaterDispenser Models
Tubing C lamp,_,_ 1/4"TI_
[] TURN THE WATER ON AT THE
SHUTOFF VALVE
Iighten any com_ections that leak
Reattach the access covel,
18