GE 20 Owner's Manual & Installation Instructions page 10

Installati
I struct
Models20,22,25
Questions? Ca//800,GE,CARES(800,432,2737)or Visitour Website a t: OEAppliances,com
In Canada, ca//1.800.567.3344 or VisitourWebsite
a t:
www.geappliances.ca
BEFORE YOUBEGIN
Read these instructions completely and carefully,
. IMPORTANT - Savethese
instructions for local inspector's use.
" IMPORTANT - Observea,,
governing codes and ordinances.
,
Note
to Installer - Be sure to leave these
instructions with the Consumer.
. Note to Oonsur_er - Keep these instructions
for future reference.
. Ski. level - Installation of this appliance requires
basic mechanical skills.
, Completion time - Refrigerator Installation
15 minutes
, Proper installation is the responsibility of installer.
, Product failure due to improper installation is not
covered under the Warranty.
REFRIGERATOR LOCATION
, Do not install the refrigerator where the temperature will
go below 60°F (16°C) because it will not run often enough
to maintain proper temperatures.
, Install it on a floor strong enough to support it fully
loaded.
ROLLERS
The rollers have 3 purposes:
[] Rollers adjust so the door closes easily when opened about
halfway
[] Rollers adjust so the refrigerator is firmly positioned on the
floor and does not wobble.
[] Rollers allow you to move the refrigerator away from the
wall for cleaning.
To adjust the to,ere, remove the base grille by pulling it out
at the bottom.
Turn the roller adjusting screws
clockwise to raise
the
refrigerator,
counterclockwise to lower it, Use an
adjustable
wrench (3/8" hex head bolt) or pliers.
.... .f J
To replace
base
grille_ line up the clips on back of grille
between the bar and the bottom of the cabinet. Push forward
until grille snaps into place.
WATER SUPPLYTO THE ICEMAKER (on some
models)
If the refrigerator has an icemaker, it will have to be
connected to a cold water line. AGE water supply kit is
available at extra cost from your dealer, by visiting our
Website at GEAppliances.com (in Canada, at
www.GEAppliances.ca), OFfrom Parts and Accessories,
800.626.2002.
CLEARANCES
Allow the following clearances for ease of installation,
proper air circulation and plumbing and electrical connections.
o Sides 1/8" (4 mm) o Top 1" (25 ram) * Back 1" (25 ram)
A door clearance of 3/4" (19 mm) is needed for a 90° door
opening which provides better accessto food storage area.
DOOR ALIGNMENT
After leveling,make sure that doors are even at the top.
To make the doors event adjust the refrigerator door.
O Using a 5/16" socket wrench, turn the door adjusting screw
to the right to raise the door, to the left to lower it. (A nylon
plug, embedded in the threads of the pin, prevents the pin
from turning unless a wrench is used.)
O After one or two turns of the wrench, open and close the
refrigerator compartment door and check the alignment at
the top of the doors.
10