Cleaner Descriptions; How To Use - Hoover WindTunnel U5471-900 Owner's Manual

iEl_!
Place smaller unridged end of wand
into bottom of rack. Snap wand into
clip. Repeat with other wand.
Open tool cover.
Cleaner description
A
Insert ends of dusting brush (A),
crevice tool (B) into storage areas.
Secure furniture nozzle (C)in clip.
Close tool cover.
A
[nfnnl[,'l
Remove switch lock (A) above ON/
OFF switch (B) by pulling it straight
out. Dispose of switch lock.
If switch lock has come off during
assembly, make sure switch is in
OFF position (down) before plug-
ging cord into electrical outlet.
1/4
22 23
10 f
1 3
The assembled cleaner will
look like the drawing.
1. Handle
2. ON/OFF switch
3. Cord hooks: wrap cord
around hooks for storage.
The top hook can be
rotated right or left for
easy cord release.
4. Hose
5. Tool cover
6. Dusting brush
7. Furniture nozzle
8. Crevice tool
9. Carrying handle
10. Wands
11. Final filter door
12. Handle release lever:
step on lever to lower
handle to operating or
low positions.
13. Edge groomers
14. Furniture guard: helps
prevent cleaner from
marking furniture.
15. Nozzle control knob: slide
knob to correct setting for
height of carpet being
cleaned.
16. Headlight
17. Embedded Dirt FINDER
TM
sensitivity switch*
18. 'Dirt FINDER' display*
19. Check bag indicator
20. Stair cleaning handle:
located below lower edge
of door.
21. Bag door
22. Cord clip
23. Hose rack
*some models only
Operate cleaner only at volt-
age specified on data plate
on bottom of cleaner.
This cleaner is intended for
household use.
Polarized plug
To reduce the risk of electric shock,
this appliance has a polarized plug
(one blade is wider than the other).
This plug will fit in a polarized outlet
only one way. If the plug does not
fit fully in the outlet, reverse the
plug. If it still does not fit, contact a
qualified electrician to install the
proper outlet. Do not change the
plug in any way.
ON-OFF switch
Plug cord into electrical outlet.
To turn cleaner ON, push switch up.
To turn cleaner OFF, push switch
down.
Cord clip
To help keep the cord out of the way
while vacuuming, position cord in
cord clip (A)located at rear of
cleaner on hose rack.
Continued _ s