Hitachi CP-X970W User Manual page 13

Basic operations
To project 1
1
_
5 7 4 2
m
5_
j4
1
Turn on the main power switch of the projector [ I: ON].
• The Power indicator lights orange.
Press the STANDBY / ON button.
• The Power indicator will blink green and then light green.
• The green blinking indicates wannup.
3
Remove the lens cap.
4
Use the ZOOM button to adjust the screen size.
5
Use the FOCUS button to adjust the focus.
( 1) The display shown to the right will appear when the FOCUS button is pressed. + + + FOCUS+ + +
(2) Use the FOCUS button to adjust the focus until the image is sharp.
(3) The message "Focus" will disappear if any other button is pressed.
• (When there is no input signal, the Focus characters are not displayed when the input signal is outside the sync range.)
6
Turn on the power to the connected equipment.
Refer to page 31 concerning the connection of other equipment.
7
Press either the INPUT button of the
projector or the VIDEO/RGB button of the
remote control to select the signal to be
projected on the screen.
The selected signal input channel will be displayed in the lower right part of the screen.
Exampleon-screendisplay
RGB 1
13