Wall Mounting - Hitachi L32A403 Operating Manual

How To install Your New Hitachi LCD Television
WALL MOUNTING SETUP
STEP (1) : REMOVE THE STAND BASE FROM THE LCD TELEViSiON
In order to remove the stand from the TV, please put the TV set on a soft and flat surface (blanket, foam, cloth, etc.) to prevent any
damage; then remove the 4 screws shown below in order to separate the TV from the Table Top Stand. Now the Stand can be separated
from the TV. Useful dimensions for the WALL MOUNT assembly are in page 39 and 40.
(a) 4 Screws ((a) M4 and
(a: _ _(b) (b) tapping ...... )Do
_,,,J
Stand Base
STEP (2) : INSTALL THE WALL MOUNT BRACKETS ON THE LCD TELEVISION USING 4 SCREWS.
ooooOOOlO111111OllOOlIIt1_ w 11oooI1_I_11111IlOOOoloo1_#II111oooolll w 1_1111oolII1_IIIIIlOOOI1_
\ _ [Screw Mounting Holes (4 locations). Don't]
//-
-_
_use the original screws (A) that were|
p,_t_ " lin the Tv f°r the Table T°p Stand The|
|original screws are not long enough to|
|properly secure the TV to the wall bracket.J
.......... (9" i
iiiioooooooooooo i11oooll ti_,ll i_,,,111oo,IIIIIIIII I 1,1111oo._,1 i I Wall Mount Brackets ]
o For Wall Mount assembly; please refer to the Installation Manual of the
Wall Mount Unit.
<
Screw Length (A)
Insertion length (B)
Spring Washer (C)
Plane Washer (D)
Wall Mount Bracket (E)
Example :
A = B+C+D+E
A: 13.5~15.5 ram.
_B:8.5-10.5 rnrn.
C: 1 ram.
D: 1 ram.
E:3 mm.
The screw type :Thread ISO M6 (Metric
type, do not use Standard type),
STEP (3) : TIPS TO CONSIDER FOR THE LOCATION OF THE LCD TELEVISION.
Although this L CD Display Panel can be installed using a variety of third party wall mounting brackets/devices,
third party brackets/devices have not been tested or approved by Hitachi for use or compatibility with this
Display Panel. Accordingly, Hitachi accepts no responsibility or liability for any injuries or property damage
resulting from the use of such third party brackets/devices. Hitachi strongly advises that any installation of
this LCD Display Panel using wall mounting brackets/devices be performed only by a qualified and experienced television installation
technician who has completed a thorough evaluation of:
a) the weight-bearing strength and stability of the intended wall mount surface; and
b) the weight-bearing strength and compatibility of the intended waft mount brackets/device.