Gibson GTF1040FS3 Operating Instructions

OPERATING INSTRUCTIONS
Wash / Rinse Temperature
W_ Cod
Cold Cold
Yes
Extra Rinse
No
Door
Lock
©
Final Spin Speed
Normal Fast
Cycle Signal
On
Knits / Delicates
Wash
OFF
Final Spin
off
Extra Car
Was
Colors
Final Sl
Final Spin
Whites
Heavy Wash
Wash
Light
Wash
FinalSpin
Short
Before Operating Your Washer
Read your washer Use and Care Guide. It has
important safety and warranty information. It also
has many suggestions for best washing results.
To reduce the risk of fire, electric shock,
or injury to persons, read the IMPORTANT SAFETY
INSTRUCTIONSin your washer Use and Care Guide
before operating this appliance.
Operating Steps
Read and follow Washing Procedures in your Use
and Care Guide. It provides detailed information for
preparing the wash load and choosing control
settings to ensure best washing results.
1. Sort laundry into loads that can be washed
together.
2 Prepare items for washing
Printed in U. S. A.
3 Pretreatstains andheavysoil.
4 Add laundry load to the wash drum.
,
Open the dispenser drawer and add the
measured amount of detergent to the
detergent compartment, if desired, add liquid
bleach and fabric softener to the appropriate
compartments. Slowly dose dispenser drawer.
Drawer should be completely closed for
laundry additives to dispense.
6 Set Temperatures switch according to fabric
type and soil level of each load.
7. If desired, select Extra Rinse in Whites/
Regular, Colors/Perm Press, or Delicates
cycle.
8. Select Final Spin Speed as desired.
9 Push in the cycle selector knob and turn it
clockwise to the desired wash cycle and
setting.
10
Wash Wash
Start the washer by closing the door and
pulling out the cycle selector knob. The
washer will not operate with the door open.
As a safety measure, the door will
automatically lock during the entire wash
cycle. When the door is closed, the Door Lock
Indicator lights up when the washer starts,
and turns off at the end of the cycle.
To stop the washer, push in the cycle
selector knob.
To change a cycle, push in the cycle
selector knob and turn it clockwise to the
desired setting.
Pull out the knob to restart the washer.
1 1. Remove items when cycle ends, A signal
will sound at the end of the cycle when the
Cycle Signal ON is selected.
Note: From time to time you may see water in
the bleach and fabric softener compartments.
This is a result of the siphoning action and is
part of the normal operation of the washer.
P/N 134876400 (0702)