10, 20, 30 Amp Locking Receptacle - Generac Portable Products 4000XL 9777-2 Owner's Manual

Generac Portable P roducts 4,000XL G enerator
120/240 Volt AC, 20 Amp Locking
Receptacle
Use a N EMA LI4-20 plug with this receptacle. Connect a
4-wire cord set rated for 250 Volts at 20 Amps (or greater)
(Figure 9). You can use the same 4-wire cord if you plan to
run a 120 Volt load.
I[e_ IP, T e]kV_mF.'T__ _m
4-Wire Cord Set
Y (Hot) x (Hot)
Ground
N EMA L14-20 (Green)
This receptacle powers 120/240 Volt AC, 60 Hz, single
phase loads requiring up to 2,400 watts of power at
20 Amps for 120 Volts; 4,000 watts of power (4.0 kW) at
16.7Amps for 240 Volts. The outlet is protected by a
20 Amp push-to-reset circuit breaker.
120 Volt AC, 30 Amp Locking
Receptacle
Use a NEMA L5-30 plug with this receptacle. Connect a
3*wire cord set rated for 125 Volts AC at 30 Amps to the
plug (Figure 10).
3-Wire Cord Set
r-- Neutml
120V
Hot
NEMA L5-30
Use this receptacle to operate 120 Volt AC, 60 Hz, single
phase loads requiring up to 3,600 watts (3.6 kW) of power
at 30 Amps. The outlet is protected by a 30 Amp
push-to-reset circuit breaker.
12 Volt DC, 10 Amp Receptacle
This connector (identified by the legend"12-VOLT D.C:')
supplies 12 Volts DC at 10Amps through battery charging
cables for recharging 12Volt batteries (Figure I I). See
"Charging a Battery" on page 7.
iBm
9