GE JGP640 Use And Care & Installation Manual page 16

Duct Pieces
6" round,
straight
3¼"x 10"
straight
(_ 6", 90°
elbow
6", 45 °
elbow
3¼"x 10"
90 ° elbow
(_ 3¼"x 10"
45 ° elbow
Equivalent
Length*
1ft.
(per foot
length)
1ft.
(per foot
length)
15ft.
9ft.
16ft.
5ft.
Number
Used
feel
feel
3¼"x 10"
90 ° flat elbow
i_ 6" round
to 3¼"x 10"
transition
I_ 3¼"x 10"
to 6" round
transition
[_ 6" round
to 3¼"x 10"
transition
90 ° elbow
[_ 3¼"x 10"
to 6" round
transition
90 ° elbow
(_ 6" round walt
cap damper
3¼ " x lO"wall
ap with damper
18ft.
7ft.
5ft.
20 ft.
12ft.
21ft.
27 ft.
6" round
roof cap
20 ft.
6" round
roof vent
24 ft.
Total
Equivalent
Length
Should not exceed 75 ft
Total ducl
run
* Equivalent lengths of duct pieces are based
on actual tests conducted by GE Evaluation
Engineering and reflect requirements for good
venting performance with any downdrafl cooktop.
16
STEP!0
ELECTRICAL CONNECTION
Electrical requirements:
120 volt, 60 Hertz, individual, properly grounded
branch circuit protected by a 15 amp circuit
breaker or time delay fuse.
GROUNDING
IMPORTANT: (Please read carefully.)
FOR PERSONAL SAFETY, THIS APPLIANCE
MUST BE PROPERLY (;ROUNDED.
The power cord of this appliance is equipped
with a three-prong (grounding) plug which
mates with a standard three-prong grounding
wall receptacle to minimize the possibility of
electric shock hazard from this appliance. The
customer should have the wall receptacle and
circuit checked by a qualified electrician to make
sure the receptacle is properly grounded and has
correct polarity.
Where a standard two-prong wall receptacle is
encountered, it is the personal responsibility and
obligation of the customer to have it replaced
with a properly grounded three-prong wall
receptacle in accordance with the National
Electrical Code.
Do Not, Under Any Circumstances,
Cut Or Remove The Third (ground)
Prong From The Power Cord.
Do not use an extension cord with this appliance.
STEP!!
CHECKIGNITION
Assemble burners
as shown. All
parts are keyed
and only fit one
way. Push in one
knob and turn to
HIGH position,
(90° from OFF).
The igniter will
spark and the
burner will light;
the igniter will
cease sparking
when the burner
is lit. Turn the
knob to OFF
position; repeat
procedure for each burner.
Top grate
Burner
Cap