Using The Dishwasher - GE Monogram ZBD6800 Owner's Manual

Using the dishwasher
Dishwasher
Lighting
l )'atures (on
some models)
Interior Lights (on some models)
The interior Xenon lights provide better
visibility tot loading and unloading. Thev come
on when the door is opened and tuYn oJ[i[when
the door is latched. The lights will turn oIt atter
15 minutes if the door remains tmlatched. To
turn the lights back on latch and reopen the
(looE
End-of-Cycle Indicator Light (on some models)
The end-ot:cvcle indicator light is located on
the right side of the dishwasher, above the
handle. This light comes on when the selected
cvcle and enhancements are complete. The
light will stay on tmtil the door is opened. The
dishes may be rein oved at anv time.
Do not attempt to replace the bulbs. If light
bulb replacement is necessary, please contact
the GE Answer Center t0r service by calling
1.800.696.2000.
Note that the high-efficiency tan will rtm quietly
fi)r 30 minutes to 4 hours (depending on the
selected cycle) after the end-ot_cvcle indicator
light is illuminated to continue drying the
dishes. Opening the door and pressing any
keypad will stop the tim.
Waler
7bmperature
The entering water must be at least 120°F
(49°C) and not more than 150°F (66°C), tiw
efli_ctive cleaning and to prevent dish damage.
Check the _z_ter temperature with a candy or
meat thermometer Turn on the hot water fimcet
nearest the dishwasheL place the thermometer
in a glass and let the water mn continuously into
the glass tmtil the temperatm'e stops rising.
Use a Rinse
Agent
A rinse agent improves (li T peril)finance,
reduces spots and prevents new fihn build-up
on your dishes, glasses, flatware, cookware
and plastic. Jet-Dry ® and Cascade Rinse Aid ®
are recommended rinse agents lot Monogram
Dishwashers.
The rinse agent dispenser holds 3.5 oz. of rinse
agent. Under nomml conditions, this will last
approximately one month. Try to kee I) it flfll,
but do not overfill.
To fill the rinse agent dispenser; make sure the
dishwasher is flflly open.
Turn the dispenser cap to the left and lift it
Otlt. Add rinse agent tlntil the indicator window
shows fldl.
Clean up any spilled rinse agent with a damp
cloth. Replace the dispenser cap.
The anlount of rinse agent released into the
final wash can be a(!justed. The thcto_ T setting
is at the midpoint. If there are rings of calcimn
(hard water) spots on dishes, try a higher
setting. If there is toaming, use a lower setting.
To a(!just the setting, remove the dispenser cap;
then ttlrn the a(!juster counterclockwise to
increase the anlount of rinse agent.
Rinseagent
adjuster