GE AZ55H12EABM1 Owner's Manual And Installation Instructions page 9

vvww.GEAppliances.com
Door Sensor (Obtained locally)
_]/en connected, tile door sensor will detect
when tile door in tile i'OOill W_lS opened or
closed. This teatm'e must be used in coI_junction
with tile motion senso_:
The door and motion sensm_ work together
to automaticallx mrn tile refit ON or OFE
g g
_DoorSensor
External Fan (Obtainedlocally)
_41/en connected, an auxiliary or external tim
can be controlled with tile indoor
tim motor
on the Zoneline, Connections provide 94 V AC
to energize a remote relay, turning on the
external tim.
_ External Fan
Central Desk Control
X_]/en com_ected, tile refit can be turned ON
or OFF with a switch located at the Central
Control Panel. A separate wire pair must be
run fl'om each separate controlling switch to
each individual Zoneline.
hi® ® ® ® ® ® ®l®l®l®l®j®l®l®
g
_CentraIDeskControi
Remote Thermostat
X_q/en connected, tile refit _fill be controlled
bv a i'elllote thelilloStat.
NOTE'The number 4 dip switch must be in tile
enabled (liP) position to activate tile remote
them_ostat, (See the installation instructions
supplied with the remote them_ostat),
IMPORTAN7?
Tile Zoneline them_ostat connections
provide 24 V AC only
If using a digital/electronic wall them_ostat,
you must set it to tile 24 V AC setting.
See tile Installation Instructions for tile
wall them_ostat.
q;H;l*lq;I.Iq.lq
z m
o
Red 24 V AC only
Green- Low Speed Fan
Green High Speed Fan
Black- Solenoid
Yellow Compressor
White - Heater
Common Ground
CAUTION:
Damage to a wall them/ostat or to tile
Zoneline electronics can result fl'om improper
connections. Special care must be used in
cmmecting blue and black wires. No line w)ltage
connections should be made to any circuit.
Isolate all wires in building fl'om line w)ltage.