Auxiliary Controls - GE AZ55H12EABM1 Owner's Manual And Installation Instructions

Auxiliary Controlson yourZoneline. _.CEA,,,ia.ces.com
Auxiliary Controls- Dip Switches
The au_lim y dip switch controls are located
behind tile room cabinet, through an opening
below the control panel.
Remove tile room cabinet. See tile ToRemove the
Room Cabinet section.
Tile ti_ctoxy settings will be in tile
DOWN
position.
Tile owner is responsible for checking switches
and ensm_ing tile) are in tile desired position.
C: FANCN(Cooling-SmartFan)
H: FANBY(Heating-SmartFan)
CLASS 2 (Remote Thermostat
LOADSHEDDING (CDC)
FREEZ S en(Freeze Sentinel)
CONST FAN(Constant O N Fan)
OCCUPIED ( Occupancy Sensor)
m
7 t_
Dip Switches
L
DIAGNOS (Diagnostic Check)
BOOST (HeatBoostOperation)
rL1(H)(Temp. L imit 1-Heat)
TL2(H)(Temp. L imit 2-Heat)
TL3(H)(Temp. L imit 3-Heat)
TL1(C)(Temp. L imit 1-Cool)
TL2(C)(Temp. L imit 2-Cool)
TL3(C)(Temp. L imit 3-Cool)
All Electric Heat
X,_hen this switch is enabled (UP), heat pump
operation is locked out, causing tile trait to
proxide only electric resistance heat.
°%° a SmmaEIB_ BalfllflaaBl_ioa_,
L ALLPR (All ElectricHeat)
Cooling-Smart Fan
_]/en this switch is enabled (UP), it allows tile
indoor lira to cycle on/off with tile compresso_:
X4]mn this switch is disabled (DOWN), it allows
the indoor tim to mn continuously.
°a_° B[BI_81_88B8 888888B8i °°%°
L C: FANCN(Cooling-SmartFan)
Heating-Smart Fan
When this switch is enabled (UP), it allo_vs tile
indoor tim to run continuousl); When this
switch is disabled
(DOWN), it allows tile indoor
tim to cycle on/off with tile heat I)ump
or
heater oi)eration.
o ,iaa,aaa i aa ?,
L H: FANCY(Heating-SmartFan)