Specific Safety - DeWalt DC413 Instruction Manual

caught inmoving p arts. Airvents o ften cover m oving p arts and
should a lso beavoided.
• Avoid accidental starting. Be sure switch is in the locked or
off position before inserting battery pack. Carrying tools with
your finger on the switch or inserting the battery pack into a tool
with the switch on invites accidents.
• Remove adjusting keys or wrenches before turning the tool
on. A wrench or key that is left attached to a rotating part of the
tool may result in personal injury.
• Do not overreach. Keep proper footing and balance at all
times. Proper footing and balance enables better control of the
tool in unexpected situations.
• Use safety equipment. Always wear eye protection. Dust
mask, non-skid safety shoes, hard hat, or hearing protection
must be used for appropriate conditions.
TOOL USE AND CARE
• Use clamps or other practical way to secure and support the
workpiece to a stable platform. Holding the work by hand or
against your body is unstable and may lead to a loss of control.
• Do not force tool Use the correct tool for your application.
The correct tool will do the job better and safer and the rate for
which it is designed.
• Do not use tool ff switch does not turn # on or off. Any tool
that cannot be controlled with the switch is dangerous and must
be repaired.
• Disconnect battery pack from tool or place the switch in
the locked or off position before making any adjustments,
changing accessories, or storing the tooL Such preventative
safety measures reduce the risk of starting the tool accidentally.
• Store idle tools out of reach of children and other untrained
persons. Tools are dangerous in the hands of untrained users.
• When battery pack is not in use, keep # away from other
metal objects like: paper clips, coins, keys, nails, screws, or
other small metal objects that can make a connection from
one terminal to another. Shorting the battery terminals together
may cause sparks, burns, or a fire.
• Maintain tools with care. Keep cutting tools sharp and clean.
Properly maintained tools, with sharp cutting edges are less likely
to bind and are easier to control
• Checkformisalignmentorbindingofmovingparts, breakage
of parts, and any other condition that may affect the tool's
operation, ff damaged, have the tool serviced before using.
Many accidents are caused by poorly maintained tools.
• Use only accessories that are recommended by the
manufacturer for your model Accessories that may be suitable
for one tool may become hazardous when used on another
tooL
SERVICE
• Tool service must be performed only by qualified repair
personneL Service or maintenance performed by unqualified
personnel could result in a risk of injury.
• When servicing a tool, use only identical replacement
parts. Follow instructions in the Maintenance section of
this manual Use of unauthorized parts or failure to follow
Maintenance Instructions may create a risk of electric shock or
injury.
Additional Specific Safety Rules
• Check that the grinding wheel backing flange has a yellow rubber
ring (K) installed, see Figure 3. Replace rubber ring if missing,
damaged or worn. See page 10 for details regarding proper
accessory installation.