GE Spacemaker WSSH300 Owner's Manual & Installation Instructions page 20

Error Codes
If the washer stops, an error code flashes and the signal beeps periodically, press PAUSE/CANCEL Consult the Error Code
Chart below for the possible cause and solution. If Control Lock is on when an Error Code occurs, the controls will unlock.
Make the correction, select a cycle and press START.If the error code flashes again and the beeping continues, please
contact service for assistance.
poss,h,eCa.ses
What ToDo
1. Water doesn't enter
Water supply to the home
is interrupted
" Check to see if water flo_:s adequately flxm] other fimcets
in the l_ome; wait tor service to be restored.
Water pressure is too low
" Avoid
framing water in other areas of the home when
doing laundry.
Water may not be tttnled on • Fully ol)en supply filt/cets to washeL
or faucet may not be fully
opened
Hoses are kinked or drain pipe • Straighten hoses. Raise height ol bend in drain hose
is below mhfimum height of 24" to a mininnuu of 24".
1,Water leaks
Hose comaections are loose • Tighten inlet hose ('(ml]ecfiol]S at til ucets mid wash el:
Household drahlis clogged • tlnch)g household drain.
OversudsJng " Use high eiiiciency detergent in the amount
reconuuended on tile label.
2, Water doesn't drain Drain hose is ki_ked or • Straighten hose and unclog household
drain.
household drain is clogged
3,
Drum overfilled hflet valve, pressure swhch • Do not open doon Select Drain/Spin to remove water;
or conlrol board failure restart tile cycle.
4, Door is open
Washer _dll not operate • Close tile wash er (h)()n
if the door is open
5, Motoris overheated
Washer motor stops • _Vlit 30 minutes fin" n]otor to cool down.
if overheated
7, Cold water doesn't
Cold water hose is comzected • Connect tile hose to tile cold water timcet and tile cold
enter washer to wrong faucet water inlet on tile washel:
Cold water faucet is not tunled on " Be sure cold water thucet is filly opened.
15,Oversudsing
A
high
efficiency detergent " Use only a high efficiency detergent. Folh)w
was not used
l/1}ll][/tiIctI/l'eI"S
l'eCOl/lUlel]datio1]
tOF dosage.
Too lnuch detergent was added " Tile amount may l]eed to be a(!justed for water
teIul)eratul'e, water hardl]ess, load size and soil level.
15,Hot waterdoesn'tenter
Hot water hose is comlected • (_ouuect tile hot water hose to tile hot water fimcet
to the wrong faucet and the hot water inlet on file washeL
Hot water faucet isnot trolled on " Be sure tile hot water fiulcet is fully ol)el]ed.
2O