GE DBVH520 Owner's Manual page 22

Stacking.
INSTALLINGTHE STACKBRACKETKIT (cont.)
............. --::....................
4. Prepare the Washer
and Dryer
A. Place the washer in the approximate
location.
B. Make sure the washer is level.
Refer to washer Installation
Instructions for details.
C. Remove the back portion of
the control panel bg removing
the 3 screws.
O. Reverse drger door swing if desired.
See drger Installation Instructions
for details.
NOTE:The washer door swing is not
reversible.
.
A.
Install Dryer and Bracket
on Washer
Lift the drger on top of the washer.
Be careful not to scratch the top
of the washer with the brackets.
Protect the washer control panel
with cardboard or other protection.
Be sure to lift the dryer high enough
to clear the washer control panel.
WARNING!
Potential Personal InJury. More than
two people are recommended to lift
the dryer into position because of its
weight and size. Failure to do so could
result in personal injurg or death.
B. Align the holes in the bracket
with the holes in the back of
the washer Using a Phillips
screwdriver, attach the 2 #8 x 1/2"
tapping screws. Repeat on both
sides of the washer.
Place
hands 1
here_
/
Place
nanas
nere
6,
A.
Finalize the Installation
Refer to the washer Installation
Instructions to complete the washer
installation.
Refer to the drger Installation
Instructions to complete the drger
installation.
Carefullg slide or walk the stacked
washer and drger into place. Use
felt pads or other sliding device
to assist moving and to protect
flooring.
WARNING!
Potential Personal InJury. Do not push
on the dryer once installed to top of
the washer. Pushing on the dryer may
result in pinched fingers.
22