GE GSD3400 series Owner's Manual page 21

Possible Causes What To Do
Dishesandflatware
notclean
Lowinlet water Make sure inlet water
temperature,
temperatureis correct
(see page 12).
Use HOTSTARToption.
Water pressure is Turn on a tmlcet. Is water
temporarily low coming ()tit more slowl}
than usual? It so, wait until
pressure is normal bet0re
using your dishwasher.
Air gap is clogged Clean the air gap.
Improper rack loading Make sure large dishware
does not block the
detergent dispenser or the
wash arm,
Spotsandfihning
on glassesand
flatware
Extremely hard water
Low inlet water
temperature
Overloading the
dishwasher
Improper loading
Old or damp powder
detergent
Rinse agent dispenser
empff
Too little detergent
Use Jet-Dry ® rinse agent to
remove spots and prevent
new t]lm build-up.
To remove stubborn spots
and pre-existing film ti'om
glassware:
I Remove all metal utensils
ti'om tile dish_casher.
2 I)o not add detergent.
3 Select the longest Q_le.
4 Start the dishwasher and
allow to mn t0r 18 to 22
nfinutes. Dish_casher will
nowlye in tile main _vtsh.
5 ()pen the door and pour
2 cups (500 nil) of whim
vinegar into tile l)ottoln ot
the dishwasher.
O (;lose the door and alh)w
to complete tile c?vle.
It vinegar rinse doesn't
work: Repeat as above,
except use 1/4 cup (60 ml)
of citric acid crystals
instead of vinegar.
iii:llil
i_iiL J,!,ii{ii{i/i
iiiiiiiii iii!
2/