Glass Cooktop - GE PP989 Owner's Manual & Installation Instructions

Cleaning the glass cooktop,
ge.com
Clean yourcooktopalter
each spill. Use CERAMA
BRYTE ® CeramicCooktop
Cleaner.
Normal Daily Use Cleaning
ONLYuse CERAMA BRYTE ® Ceramic
Cooktop Cleaner on the glass cooktop.
Other creams may not be as effective.
To maintain and protect the surface of
your glass cooktop, follow these steps:
[]
Before using the cooktop for the
first time, clean it with CERAMA
BRYTE ® Ceramic Cooktop Cleaner.
This helps protect the top and makes
clean-up easier.
[_ Daily use of CERAHABRYTE ®Ceramic
Cooktop Cleaner will help keep the
cooktop looking new.
%
Shakethe cleaning cream well,
Apply a few drops of CERAMA
BRYTE ® Ceramic Cooktop Cleaner
directly to the cooktop.
Use a paper towel or CERAMA
BRYTE ® Cleaning Pad for Ceramic
Cooktops to clean the entire cooktop
surface.
J_ Use a dry cloth or paper towel
to remove all cleaning residue.
No need to rinse.
NOTE: It is very important that you DO
NOT heat the cooktop until it has been
cleaned thoroughly.
Usea CERAMA BRYTE ® CleaningPad
for CeramicCooktopsor a Scotch-Brite ®
Multi-PurposeNo Scratchblue scrub
pad.
Burned-On Residue
WARNING: DAMAGE
to
your glass surface may occur if Fou use
scrub pads other than the pod included
with your cooktop.
[_ Allow the cooktop to cool.
[_ Spread a few drops of CERAMA
BRYTE ®Ceramic Cooktop Cleaner
to the entire burned residue area.
%
Using the included CERAMABRYTE ®
Cleaning Pad for Ceramic Cooktops,
rub the residue area, applying
pressure as needed.
[]
%
If any residue remains, repeat the
steps listed above as needed.
For additional protection, after all
residue has been removed, polish
the entire surface with CERAMA
BRYTE ®Ceramic Cooktop Cleaner
and a paper towel.
The CERAMA BRYTE ® CeramicCooktop
Scraperand all recommended supplies
are availablethroughour PartsCenter.
Seeinstructionsunder"To OrderParts"
section on next page.
NOTE:Do not use a dull or nicked
blade.
Heavg, Burned-On Residue
%
[]
Allow the cooktop to cool.
Use a single-edge razor blade
scraper at approximately a 45 °
angle against the glass surface and
scrape the soil. It will be necessary
to apply pressure to the razor
scraper in order to remove the
residue.
%
[]
After scraping with the razor
scraper, spread a few drops of
CERAMA BRYTE ® Ceramic Cooktop
Cleanerto the entire burned residue
area. Use the CERAMABRYTE ®
Cleaning Pad to remove any
remaining residue.
For additional protection, after all
residue has been removed, polish
the entire surface with CERAMA
BRYTE ®Ceramic Cooktop Cleaner
and a paper towel.
ll