GE TFH22PRXAAA Owner's Manual page 20

Installing the water line.
Read these instructions completely and carefully.
Connect the Tubing to the Refrigerator
Before making the connection to the
refrigerator, be sure the refrigerator power
cord is not plugged into the wall outlet.
We re( ommend installing a water fiber if your water
supply has sand or parfi(les that could (log die
s( reen of die refiigerator's water valve. Install it in
die water line near [lie reiiigerator.
_] Remo_ e [lie plastic flexible cap flom [lie wa[er
_alve (refiigeramr (onne(don).
_ Place [lie compression nm and ferrule (slee_ e)
onto the end ({f[he [ubing as shown.
[_ Insert the end of the copper robing into
[lie wa[er _alve refiigerator ( onne( tiof_ as fhr
as possible. While holding [lie robing, dgh[en
[lie fiuing.
_] Fasten [lie copper robing into the damp
provided to hokI it in posidon. You may
need [(1 l)tT open [lie clamp.
Oneof the i//ustrationsbe/ow wi// /ook /ike the connection
on yourrefrigerator.
_ ubingClamp
1/4"
Compression
Nut
TubingClamp 1/4" Compression N ut
Ferrule(sleeve)
Connectioll
Tubing
Turn the Water On at the Shutoff Valve
_] Tigluen any ( onne( dons dm[ leak
_ Repla( e [lie a((ess (over arid strews (oil soiTtle
models).
Plug In the Refrigerator
Arrange [lie coil of copper robing so tim[ it does not
vibrate agains[ [lie ba(k of din refiigeramr or agains[
[lie wall.
Push [lie refligeraU)r back [(1 [lie wall
Start the Icemaker
Set the icemaker teeler arm to the ON (down)
position. The icemaker will not begin to operate
until it reaches its operating temperature of 15 °F
(4)°C) or below. It will then begin operation
automatically if [lie i( emaker _eeler arm is in [lie
ON (down) position.
NOTE:Theicemakermay doub/e-cyc/e whenit hYst s tarts,
causingsomewater spillage from the/2emakerinto the
ice bucket.This/s normalandshouldnot happenaga/k
20