Table of Contents
Advertisement
PREPARATXON
(continued)
Rollers
Adjustable rollers behind the base grille enable you to
move the refiigerator
away from the wall for cleaning.
Tho_:o
rnllor,_
chnnld
he cot ca the
raf'rierarntnr
ro,._tc
firmly on the floor. To assure that the doors will close
automatically
from a halfway-open
position, there is a
built-in tilt from the front to the back of the cabinet.
Side-by-side
mfiigerators
also have specially designed
door hinges that lift both doors slightly when opened,
,qllnwina
the fnreo
nf arnvitv
to haln
cln_
tharn
_aenr_lv
the base grille by grasping
[ [
it at the bottom and pulling [ [
it out.
-[I
_
" _"="_'_"
Turn roller adjusting
[ _
_<_
screws
clockwise
to raise
refrigerator,
counterclockwise
to lower it. Use
adjustable
wrench (3/8" hex head bolt) or pliers.
When adjusting front rollers
]
for proper door closure, we
raenrnmcmd
thnt thp hnft_srn
fro;,i'i U;iti e ca-bi ei;e
[
approximately
5/8" from the I
I
floor.
To replace base
grille, align prongs
on back of grille
vl/lul
_,,_ll_*J[ll]2/_
111
cabinet and push
forward until grille
snaps into place.
Water Supply to Icemaker
You wil! need to connect your icemaker
to a cold water line. A water supply kit containing
copper
tubing, shut-off valve, fittings and instructions
is available
at extra cost from your dealer. There
should be sufficient tubing fbr the icemaker
from the cold water supply to allow you to move the
refi'igerator
out from the wail several feet (approximately
8 feet of i/4" copper tubing in three
10-inch diameter
coils.)
Advertisement
Table of Contents
