GE JV566 Owner's Manual And Installation Instructions page 13

Installation Instructions
[] MARK HOLES
Select the _ent option
that _our installation
will
require and proceed to that section:
A.Outside top exhaust
(Vertical duct-31/4" x 10" Rectangular)
• Use the diagran_ or the hood as a template and
mark the locations (m the cabinet for ductwork,
electrical wiring and kevhole screw slots.
Hood mounting screws (4)
131_6 " (30" hood)
(36"
13_s/U ' (30" hood)
f Electricalaccesshole
Wood shims(recessed- 't"
Center (in cabinetbottom)
bottom cabinets o nly) line
B.Outside top exhaust (Vertical duct-7" Round)
• Use the diagram or the hood as a template and
mark the locations on the cabinet for ductwork,
electrical wiring and keyhole screw slots.
Hoodmountingscrews(4)
131_6"(30" hood) 131_6" ( 30" hood)
hood)
101//'
_- Electrical access
Wood shims (recessed- Center hole (in cabinet b ottom)
bottom cabinets only)
line
C.Outside rear exhaust
(Horizontal duct-31/4" x 10" Rectangular)
• Use the diagram or the hood as a template and
mark the locations on the cabinet for ductwork,
electrical wiring and keyhole screw slots.
Wood shims (recessed-bottom cabinets o nly)
[/_
............
Cabinet
I ] "_--_
front
I_*'
17A s '__i_
t 3_/43 _ Horizont; Iduct T
f ICabinet , I \
\ [bottom 1_-sw'
_ "11--51/4 ,' --_1
\ | _ 127A6" _
15 _ _ 15
\ _--13 _A6" (30"hood) 13'A6" ( 30"hood)
161_6" ( 36"hood) 161_16" (36"hood)
Electrical access hole
Hood mounting screws (4) Cente'r line Oo wall)
D.Recirculating (non-vented ductless-
Available on JV5 Series models only)
• Use the hood as a template and mark the locations
on the cabinet for the electrical wiring and keyhole
screw slots.
• Since the hood is to be recirculated (not to be vented
outside), do not cut out am xent ol)enings, in the wall
or cabinet bottom.
[] CHOOSE VENTING OPTION
(for JV5 Series models only)
The hood can be set to vent outside or to recirculate
air back into the kitchen.
The plastic vent lever is located near the center of the
hood opening.
• To vent to the outside, make sure the
plastic
vent
lever is in the HORIZONTAL position (fiat against
the metal top of the hood).
• To redrculate aM into the kitchen, make sure the
plastic vent lever is in the VERTICAL position
(fiat against the plastic blower housing).
NOTE: In order to change the vent lever position,
wm will need to pull the lever out slightly to clear
the plastic tabs.
Setfor Set for
outsideventing recirculating
Hoodshownlyingupsidedown