Safety In_Ttructions; Burner Assembly; Control Knobs - GE JGP932 Owner's Manual

Care and cleaning of the cooktop, www.CE4ppliances.co,,
Be sure electrical power is off and aft surfaces are cool before cleaning any part of the cooktop.
How to Remove Packaging Tape
To assure no (lamage is done to the finish
of the product, the saiest way to remove
the adhesive left from packaging tape on
new appliances is an application of a
household liquid dishwashing dem_gent,
mine_M oil or cooking oil.
Apply %fl_ a soft doth and allow to soak.
_._]pe (h_' and then apply an appliance
polish to thoroughly clean and protect
the sudi_ce.
NOTE."Theplast]> tape must be removed from all
chrome tnm. It cannot be removedif it is baked on.
©
I
_1
Pull the &Tobstraight off the stem.
Control Knobs
Clean up spatte_ with a damp cloth.
Remove heavier soil with w;mn,
soapy water:
Donot use abrasivesof any k/bd on the
control panel
The control knobs may be removed fin.
easier cleaning. To relnove a knob, pull it
straight off the stem. _.V_sh the knobs in
soap and wateI" gilt do not soak.
Burner
CAUTION:DO NOT OPERATE THE
BURNERWlTHOUTALL BURNER
PARTSIN PLACE
Burner Assembly
The burner assemblies should be washed
regularl) and, of com_e,
after spilloxe_.
Turnall controls off before remov]bgburner parts.
The burner grates, burner heads and
btlYneI" caps C[lll
be
removed fi)r
easy
cleaning.
The electrode of the spark igniter is
eN)osed beyond the stli'tilce of the
bm'ner base. When cleaning the cooktop,
be careflfl not to snag the electrode of
the spark igniter with your cleaning
cloth. Damage to the igniter could occtm
To avoid snagging a cloth on the spark
igniter, leave the burner heads in place
when cleaning the cooktop.
Be careflfl not to push in any cooktop
controls while cleaning the cooktop,
A slight electrical shock might result
which could cause w>u to knock over
hot cookware.
Wash burner parts with an alli)m])ose
non-abrasive cleaner and %311111 watei;
Soak stubborn soil. Dry them with a
cloth--<h> not reassemble while wet.
To reassemble,
replace
the burner
head
fi_t, then the burner
cap and finally the
burner grate. Be sure the pins in the
burner head are properly located in the
burner base holes.
9