Table of Contents
Advertisement
Available languages
Available languages
• Makecertain
all nuts and bolts are tightened
securely. Also, be certain to reconnect the spark
plug wire before starting the mower.
Your mower
has been shipped
as a mulcher. To dis-
charge grass to the side, proceed as follows.
• To convert your mower from a mulcher to a side
discharge mower, lift the mulching plug. See fig-
ure 5. Slide the two hooks on the side discharge
deflector under the hinge pin on the mulching plug
assembly. Lowerthe mulching plug.
Mulching
Plug
Hooks
FIGURE 5.
KNOWYOUR LAWNMOWER
READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR LAWN MOWER. Compare
the illustrations with your lawn mower to familiarize yourself with the location of various controls and adjustments.
Save this manual for future reference.
Drivq
Handle
Lever
Guide
Rope
Oil Fill and
Rear Wheel
uster
line
Primer
Muffler
LEFT SIDE OF MOWER
Adjuster
Mulchin_
Plug
Spark Plug
FIGURE 6.
Wire and Boot
MEETS CPSC BLADE SAFETY REQUIREMENTS
Sears Walk-Behind Lawn Mowers conform to the safety standards of the American National Standards Institute,
and the U.S. Consumer Product Safety Commission,The blade turns when the engine is running.
BLADE CONTROL HANDLE--must be held down to
the handle to start and run the engine. Release to
stop the engine.
STARTER ROPE--used for starting the engine.
PRIMER-pumps
additional fuel from the carburetor
to the cylinder for use when starting a cold engine.
ENGINE SPEED CONTROL LEVER--permits
selec-
tion of fast or slow engine speed,
DRIVE CLUTCH CONTROL--must be held against
the handle to engage the wheel drive. Release the
drive clutchcontrolto stop the wheels from driving.
SHIFT LEVER--is used to select one of six operating
speeds for the mower.
7
Advertisement
Table of Contents
