Table of Contents
Advertisement
SERVICE AND ADJUSTMENTS
iNTERLOCKS
AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.
Check wiring. See electrical wiring diagram in the Repair
Parts section.
TO REPLACE
FUSE
Replace with 20 amp automotive-type
plug-in fuse. The
fuse holder is located behind the dash.
TO REMOVE
HOOD AND GRILL ASSEMBLY
(See Fig. 36)
•
With engine not running, move throttle control lever to
fast position.
•
Check that swivel is against stop. If it is not, loosen
cable clamp screw and pull cable back until swivel is
against stop. Tighten cable clamp screw securely.
STOP
|
•
Raise hood.
•
Unsnap headlight wire connector.
•
Stand in front of tractor. Grasp hood at sides, tilt toward
engine and lift off of tractor.
•
To replace, reverse above procedure.
HOOD
HEADLIGHT
WIRE
CONNECTOR
Fig. 36
TRANSMISSION
REMOVAL/REPLACEMENT
Should your transmission
require removal for service or
replacement,
it should be purged after reinstallation and
before operatingthetractor. See"PURGETRANSMISSION"
in the Operation section of this manual.
ENGINE
TO ADJUST
THROTTLE
CONTROL
CABLE
(See Fig. 37)
The throttle control has been preset at the factory and
adjustment should not be necessary. Check adjustment
as described below before loosening cable. If adjustment
is necessary, proceed as follows:
02119
CLAMP
SWIVEL'
SCREW
Fig. 37
TO ADJUST
CHOKE CONTROL
(See Fig. 38)
The choke control has been preset at the factory and ad-
justment should not be necessary. Check adjustment as
described below before loosening cable. If adjustment is
necessary, proceed as follows:
•
With engine not running, move choke control (located
on dash panel) to full choke position.
•
Loosen knob and remove cover assembly from air
cleaner.
•
Choke should be closed. If itis not, loosen casing clamp
screw and move choke cable until choke is completely
closed. Tighten casing clamp screw securely.
•
Replace
air cleaner
cover assembly
and tighten
knob.
CLAMP
SCREW
i
Fig. 38
TO ADJUST
CARBURETOR
Your carburetor is not adjustable. If your engine does not
operate properly due to suspected carburetor problems,
take your tractor to an authorized service center for repair
and/or adjustment.
High speed stop is factory
adjusted.
Do not adjust - dam-
age may result.
iMPORTANT: NEVERTAMPERWITHTHE
ENGINE GOVERNOR,
WHICH IS FACTORY
SET FOR PROPER ENGINE SPEED.
OVERSPEEDING
THE ENGINE ABOVE THE FACTORY HIGH
SPEED SETTING CAN BE DANGEROUS.
IF YOU THINK THE
ENGINE-GOVERNED
HIGH SPEED
NEEDS
ADJUSTING,
CONTACTYOUR
NEARESTAUTHORIZED
SERVICE CENTER/
DEPARTMENT,
WHICH
HAS PROPER
EQUIPMENT
AND
EXPERIENCE
TO MAKE ANY NECESSARY ADJUSTMENTS.
23
Advertisement
Table of Contents
