Effects Loop; Direct Output - Eden Nemesis Silver Series NA120 Owner's Manual

during the thermal standby. Your unit will come back on automatically in
1 to 3 minutes and operate normally. If the unit continues to cycle
through thermal shutdown, you should contact your local dealer for
service help.
HEAVY DUTY PROFESSIONAL USE
The Nemesis Silver Series Combos are primarily designed for small
clubs and rehearsal venues. The Nemesis Silver Series Combos run
well above normal combo loudness levels. Your unit is designed to be
played hard and to hold up well. However, it is not designed to replace,
or to perform as loudly as, the more powerful Eden separate systems. If
you find you are pushing your amplifier so hard that you are
encountering thermal standby and shut down on more than a very
occasional basis, you are pushing the unit well above the intended
operating parameters and should consider stepping up to a bigger rig.
EXTERNAL SPEAKER OUTPUT
This jack allows you to use an external extension cabinet. We
recommend an 8 Ohm extension speaker. Leave the internal speaker
Do not
switch in the on position when using the extension cabinets.
exceed a total minimum load of 4 Ohms.
SPEAKER ON / OFF
This switch turns off the internal loudspeaker and any extension
cabinets. Make certain that this switch is in the on position if you want to
play your unit and hear it on the internal loudspeaker.

EFFECTS LOOP

This is a line level output and return; it is a series circuit. This is the
place to put your line level effects. You can also use the effect send as
an aux line level output. The circuit breaks on the return jack.

DIRECT OUTPUT

9