Craftsman 917.249650 Owner's Manual page 10

CONTAINER ASSEMBLY (See Fig. 5)
No hardware required
• Place bottom half inside of top half, as shown.
• Place one foot inside bottom half and lift top haltto meet
bottom half,
• Press halves tightly together whi!e lifting top to lock into
place as shown.
IMPORTANT: BEFORE LOCKING THE TABS, HOOKED
EDGES ON BOTH HALVES MUST OVERLAP TO FORM
SEAL AS SHOWN IN INSET.
Repeat for other containers.
CONTAINER
BOTTOM
HALF
INTAINER
TOP
CONTAINER
BOTTOM
HALF
PRESS TOGETHER
' TO FORM SEAL
WHtLE _FTING
TOP HALF
TAB
ASSEMBLY CHECK: Squeeze sides of lower half of con-
tainer and check that there is no gap between upper and
lower halves. If a gap appears, unlock tabs to separate
container halves and repeat instructions above.
FIG. 5
No hardware
required
Install one container to left side first with warning to
outside of unit, Install another container center position
and one in right position.
NOTE: Right container should always overlap left container
at center supports.
Close cover and lock latch handles over center support
tubes.
CONTAINER MOUNTING (See Fig. 6)
COVER LATCH
HANDLES
CONTAINER
WARNING
CENTER
TUBES
CONTAINER
HANDLE
CONTAINER
WARNING
FIG. 6
10