Table of Contents
Advertisement
BATTERY
Your tractor has a battery charging system
which is sufficient for normal use.
How-
ever, periodic charging of the battery with
an automotive charger will extend its life.
• Keep battery and terminals clean.
: Keep battery bolts tight.
Keep small vent holes open.
NOTE:
Although multi-viscosity oils
(5W30,
10W30
etc.) improve starting in
cold weather,
these multi-viscosity oils
will result in increased
oil consumption
when used above 32°F. Check your
engine oil level more frequently to avoid
possible engine damage
from running
low on oil.
• Recharge
at 6-10 amperes
for 1 hour.
Change the oil after every 25 hours of
NOTE: The odginal equ pment battery on "operation
or at least once a year if the
your tractor is maintenance
free. Do not
tractor is not used for 25 hours in one
attempt to open or remove Caps or covers:
year.
Adding or checking level of electrolyte is
not necessary.
TO CLEAN BATTERY AND TERMINALS
Corrosion and dirt on the battery and
terminals can cause the battery to "leak"
power.
• Remove terminal guard.
• Disconnect BLACK battery cable first
then RED battery cable and remove
battery from tractor.
• Rinse the battery with plain water and
dry.
• Clean terminals and battery cable ends
with wire brush until bright.
• Coat terminals with grease or petro-
leum jelly.
• Reinstall battery (See "REPLACING
BATTERY" in the SERVICE AND
ADJUSTMENTS section of this manu-
al).
V-BELTS
Check V-belts for deterioration and wear
after 100 hours of operation and replace
if necessary. The belts are not adjustable.
Replace belts if they begin to slip from
wear.
TRANSAXLE COOLING
Keep transaxle free from build-up of dirt
and chaff which can restrict cooling.
ENGINE
LUBRICATION
Only use high quality detergent oil rated
with API service classification SF, SG or
SH. Select the oil's SAE viscosity grade
according to your expected operating
temperature.
SAE VISCOSITY GRADES
Check the crankcase
oil level before
starting the engine and after each eight
(8) hours of operation. Tighten oil fill cap/
dipstick securely each time you check the
oil level.
TO CHANGE ENGINE OIL
Determine temperature range expected
before oil change. All oil must meet API
service classification SF, SG or SH.
• Be sure tractor is on level surface.
• Oil will drain more freely when warm.
• Catch oil in a suitable container.
• Remove oil fill cap/dipstick. Be careful
not to allow dirt to enter the engine
when changing oil
• Remove drain plug.
• After oil has drained completely,
replace oil drain plug and tighten
securely.
• Refill engine with oil through oil fill
dipstick tube. Pour slowly. Do not
overfill. For approximate capacity see
=PRODUCT SPECIFICATIONS" section
of this manual.
• Use gauge on oil fill cap/dipstick for
checking level. Be sure dipstick cap is
tightened securely for accurate
reading. Keep oil at =FULL" line on
dipstick.
Air Screen
Oil
Drain-......__ _
/_-_
Plug .
Oil Fill Cap/Dip_ck -_
__.
CLEAN AIR SCREEN
Air screen must be kept free of dirt and
chaff to prevent engine damage from
overheat_g. Clean with a wire brush or
compressed air to remove dirt and
stubbom dried gum fibers.
19
Advertisement
Table of Contents
