Table of Contents
Advertisement
2. Press and hold FUNC/SET for two seconds. This ENDS the
TOUR recording session.
3. Press MODE to return to the CLOCK display.
CLEAR ALL TOUR MEMORIES
For best results, perform these steps after you download TOUR
information to the PC software.
Either:
1. Download the information to you PC (the TOUR will be
automatically cleared.
Or:
1. Deactivate the TOUR
Mode. With the END
screen shown, press the
FUNC/SET button. CLR
shows at the bottom of
the display.
2. Press and hold FUNC/
SET until donE shows at the bottom of the display.
3. Press FUNC/SET again to display 0% and confirm all data
has been cleared.
4. Press MODE to return to the CLOCK display.
NOTE
The maximum and minimum values for the various sub-
modes (i.e., max heart rate, or max altitude, etc) will remain
after all data has been cleared.
CARDIO (HEART RATE) MODE
(RS109/RP109 ONLY)
The OUTBREAKER watch is
equipped with a CARDIO Mode
and heart rate chest belt, which
together allow you to measure
your heart rate (from 25-240 beats
per minute) while exercising. You
can track your heart rate while in
the ALTI-BARO, CARDIO, or
BIKE Modes, and with the following features: Stopwatch,
Timer, Temperature, and Altimeter display.
There are five screens in the CARDIO Mode including the
HEART RATE/CLOCK/HR chart (starting) screen. They are:
16
•
HEART RATE/CLOCK/HR
chart (starting) screen,
•
HEART RATE/HR alarm on/off/
screen,
•
HEART RATE/STW (stop-
watch) screen,
•
HEART RATE/TEMP (tem-
perature) screen,
•
HEART RATE/ALTI (altimeter)
screen.
To move between them, simply
press SELECT/+.
Advertisement
Table of Contents
