Craftsman Incredi-Pull 316.794011 Operator's Manual page 15

CHECKING THE OiL LEVEL
I _ _WARNING:
OVERFILLING THE CRANKCASE MAY
CAUSE SERIOUS PERSONAL INJURY. Check the oil level
before each use. The importance of maintaining the proper
oil level cannot be overemphasized.
1. Stop the engine and allow it to cool.
2. Set the unit on a fiat, level surface, such as a workbench or
table.
NOTE: Failure to keep the engine level may cause the oil to overfill.
3. Clean the area around the oil fill plug (Fig. 8) to prevent debris
from entering the oil fill hole.
4. Unscrew the oil fill plug.
5. Look into the oil fill hole; use a flashlight if necessary. The oil
level should just touch the bottom thread of the oil fill hole
(Fig. 16). If the oil level is too low, add oil to the oil fill hole until
the oil level touches the bottom thread of the oil fill hole.
NOTE: DO NOT overfill the crankcase.
6. Wipe up any oil that may have spilled.
7. Reinstall the oil fill plug.
NOTE: Make sure the O-ring is in place on the oil fill plug (Fig. 8).
Oil Fill Hole
Bottom Thread
Fig. 16
Maximum
Oil Level
CHANGING THE OiL
Change the oil while the engine is still warm. The oil will flow freely
and carry away more impurities.
1. Clean the area around the oil fill plug (Fig. 8) to prevent debris
from entering the oil fill hole.
2. Unscrew the oil fill plug.
3. Tip the unit to the side to pour the oil out of the oil fill hole and into
a container (Fig. 17). Allow ample time for complete drainage.
NOTE: Dispose of the old oil according to federal, state and local
regulations.
4. Wipe up any oil that may have spilled.
5. Tilt the unit 30 ° to the side (Fig. 9).
6. Pour 3.04 fl.oz. (90 ml) of SAE 30 SJ oil into the oil fill hole.
NOTE: DO NOT overfill. Refer to Checking the Oil Level.
NOTE: Use the empty oil bottle saved from the initial use to
measure the correct amount of oil. Fill the bottle to the top of the
label to approximate 3.04 fl.oz. (90 ml) of oil (Fig. 18).
7. Wipe up any oil that may have spilled.
8. Reinstall the oil fill plug.
NOTE: Make sure the O-ring is in place on the oil fill plug (Fig. 8).
Fig. 17
FlU Line
Fig. 18
15