Advertisement
TO ATTACH GRASS CATCHER
1. Hook the chute mounting bracket over
the housing bracket on lawn mower.
NOTE: When the mounting bracket is in
place, the wire provided on the mounting
bracket will hold the discharge guard up.
2. Attach the grass catcher to the upper
handle by sliding the grass catcher
frame into the catcher handle bracket
on the lawn mower handle• Close flip
lid.
NOTE: Flip lid must be closed while
_erating
lawn mower.
CAUTION: Do not run your lawn mower
without discharge guard, approved grass
catcher or muleher plate in place.
Discharge
gl
Chute mounting bracket
TO EMPTY GRASS CATCHER
1. Open flip lid. Squeeze clamp ring and
remove grass catcher from plastic
chute.
2. Hold the mouth of the grass catcher
closed• Using the same hand, grasp
the catcher frame handle•
3. With the other hand, grasp the top of
the grass catcher and lift off the
catcher handle bracket.
• 4. Empty grass catcher through the flip
lid using the catcher handle provided
on the bottom of catcher•
did
Catcher
frame
handle
Catcher
handle
Grass
:atcher
mouth
chute
Housing bracket
Upper
Flip lid
handle ----_-"
Grass catcher
Catcher handle bracket
Plastic
Grass
catcher
Clamp ring
_CAUTION:
Do not operate your lawn
mower unless the bag is attached to the
plastic chute. If you are not using the
Grass Catcher, the plastic chute must be
removed from mower to allow deflector
shield to return to proper position•
CLEANING
• The grass catcher may be hosed with
water, but must be dry when used,
• Check your grass catcher often for
damage or deterioration. Through
normal use it will wear. If catcher needs
replacing, replace only with a manufac-
turer approved replacement
catcher.
TROUBLESHOOTING
CHART
PROBLEM
CAUSE
Grass Catcher
1, Cutting height too low.
is not filling
2, Lift on blade worn off.
3. Catcher not venting air.
CORRECI_ION
1. Raise cutting height•
2. Replace blade.
3. Clean grass catcher•
6
Advertisement
