Husqvarna 917.375810 Owner's Manual page 15

TO REMOVE DRIVE BELT
1. Remove drive cover and belt keeper.
2. Remove belt from gearcase pulley by
pushing down on pulley and rolling belt
off it.
3. Turn lawn mower on its side with air
filter and carburetor down.
4. Remove blade and debris shield.
5. Remove belt from engine pulley on
crankshaft.
TO REPLACE DRIVE BELT
1. Place new drive belt in the belt retain-
ers of the debris shield.
2. Route the other end of the new drive
belt through hole in housing.
3. Reinstall debris shield and blade.
4. Return mower to upright position.
5. Install new belt on gearcase pulley.
6. Reinstall belt keeper and drive cover.
NOTE: Always use factory approved belt
to assure proper fit and long life.
Drive
cove r
\
Belt
keeper
PUSH
DOWN
Belt retainers
Drive belt
Debris shield
TO ADJUST HANDLE
The handle can be mounted in a high or
low position. The mounting holes in the
bottom of lower handle are off center for
raising or lowering the handle.
1. Remove upper handle and wire tie(s)
securing cable(s) to lower handle.
2. Remove hairpin cotters from lower
handle bracket mounting pin.
3. Squeeze lower handle in to remove it
from mounting pins.
4. Turn lower handle over to raise or
lower handle.
5. Squeezelowerhandlein and position holes
onto mounting pins on handle bracket.
6. Reassemble upper handle and all
parts removed from lower handle.
__ SQUEEZE
TO ADJUST "_
Lower handle i
Mounting pin
le /
Mowing Mowing
position I , position
i I / /
I " i /
I _ / /1 "
H
_c_otter_i l_--bracke t _,,/_ I
Mounting_ _
Dn
LOW POSITION HIGH POSITION
\
\
'\
Lower
handle
ROTATE
15