Craftsman 124.34984 Operator's Manual page 44

1. Table adjustment
A. Tilting adjustment
- On underside of table support bracket, back out set screw with supplied
hex wrench, Loosen large hex head bolt, See Fig, 9
- Rotate table to desired angle right or left. Use bevel scale for precise
setting, See Fig, 10
- Tighten hex head bolt to secure table tilt. Set screw should not be
tightened when table is tilted,
- To return table to level, loosen large hex head bolt. Rotate table to level
position. Use hex wrench to retighten set screw, Securely tighten large
hex head bolt,
B. Height adjustment
Loosen the clamp bolt then adjust the table to your desired position by
turning the table bracket crank handle. See Fig. 11
C. Swing Adjustment 360 °
Loosen the table swing locking handle, then swing table to desired
position and retighten the handle, See Fig. 12
Crank
handle
Figure 9
Figure 10
Figure 11
Figure 12
10