Craftsman 247.289150 Operator's Manual page 115

CuttingDecklemovai
To remove the cutting deck, proceed as follows:
1. Place the PTO (BladeEngage) l everinthe disengaged (OFF) p ositionand
engage the parkingbrake.
2. Lowerthe deckbymovingthe decklift leverinto the bottomnotchon the
right fender.
3. Remove t he self-tapping screw(A)thatsecures the belt-keeper r odfrom
around the tractor'sPTO pulley,thenremove the belt keeperrod(B).See
Figure 20.
flote: Makeamentalnotewhat holethe otherendof the belt-keeper r odisinserted
infor reinstallation purposes.
4. Remove t he belt (C)from around the tractor'sPTO pulley.See Figure 20.
Avoidpinching injuries. Neverplaceyourfingers on the idler spring or
betweenthe belt anda pulleywhile removing the belt.
!
®
#
J
Figure20
5. Looking at the cuttingdeckfromthe left sideof thetractor,locatethe bow-
tie pinthatsecures the decksupportrodon the rearleft sideof the deck.See
Figure 21.Remove t he bow-tiepinthat secures t he decksupportrod,and
carefully remove the decksupportfromthe decklift arm.
6. Repeat t he above stepsonthe tractor'srightside.
Note:Thebow-tieclipsshouldbere-installedfromthe top down.
7. Movethe decklift leverintothe top notchon the rightfenderto raisethe
decklift armsup andout of the way.
Bow-Tie Clip
w
.J
Figure21
Remove t he bow-tiecotter pinsecuring the deckstabilizerrodto the deck.
Slidethe decklift rodfrom the mounlng bracketonthe deckasseenin
Figure 22.
.......,,_!_........ /_*_
iO
0
L
Zi_ 17_//;:3 ( 7 :: CZ;iii ( :: (/) <i )<_Z'_)i::g>
_} ) ]) ZIZZ} ZIT) C} /£)) g Z>
J
Figure 22
Carefully remove the PTO cablefromthe rearof the cuttingdeckby
removing the bow-tiecotterpin whichsecures it. Remove t he springfrom
the deckidler bracket. S eeFigure 23.
23