GE ETS18XBPFRBB Owner's Manual And Installation Instructions page 4

IMPORTANT SAFETY INFORMATION.
READALLINSTRUCtiONSBEFORE USING.
a, WARNING!
HOWTOCONNECT ELECTRICITY
Do not, under any circumstances, cut or remove the third (ground) prong from the power cord.
For personal safety this appliance must be properly grounded.
The power cord of this appliance is equipped with
a 3-prong (grounding) plug which nlates with a
standard 3-prong (grounding) wall outlet to
minimize the possibili b' of electric shock hazard
from this appliance.
Have the wall outlet and circuit checked by a
qualNed electridan to make sure the outlet is
propedy grounded.
Where a standard 2-prong wall outlet is
encountered, it is your personal responsibility and
obligation to have it replaced with a properly
grounded 3-prong wall outlet.
The refl-igerator should always be plugged into its
own individual electrical outlet which has a voltage
rating that matches the rating plate.
This provides tile best pe_fimnance and also
I)rexents oxerloading< house wiring circuits which
could cause a fire hazard from oxerheated wires.
Never unplug your refl-igerator by pulling on tile
power cord. Mways grip i)lug firefly and pull
straight out ti'oln tile outlet.
Repair or replace immediately all power cords that
have become fl'ayed or otherwise damaged. Do not
use a cord that sho_:s cracks or abrasion damage
along its length or at either end.
\4lien moving tile refi-igerator away from tile
wall, be carefld not to roll over or damage tile
power cord.
USEOF ADAPTER P LUGS (Ad_pter plug_ ,ot p ermitted in ConadaJ
Because of potential safety hazards under certain conditions, we strongly recommend against the
use of an
adapter plug.
Howe\'et; if )_)u must use an adapter; where local
codes i)e_nit, a
temporary connection ma)
be made
to a propedy grounded 2-prong wall outlet bv use
of a UiAisted adapter a\_filable at most local
hardware stores.
Tile larger slot in tile adapter must be aligned with
tile larger slot in tile wall outlet to provide proper
polarity in tile connection of tile power cord.
When disconnecting tile power cord fl'om tile
adapte_; always hold tile adapter in place with one
hand while pulling tile power cord i)lug with tile
other hand. If this is not done, tile adapter ground
te_ninal is very likely to break with repeated use.
If tile adapter ground temfinal brealcs,
DO
NOT USE
tile refi-ioerator_ until a I_r°I ,)er ground has been
established.
Attaching the adapter ground terminal to a wall outlet
cover screw does not ground the appliance unless the
cover screw is metal, not insulated, and the wall outlet is
grounded through the house wking Youshould have the
circuit checked by a quadded electrician to make sure the
outlet ssproperly grounded.
READ ANDFOLLOW THIS SAFETY I NFORMATION CAREFULLY.
SAVETHESE INSTRUCtiONS
4