To Install Mower; To Level Mower Housing; Side-To-Side Adjustment; Front-To-Back Adjustment - Craftsman 917.276120 Owner's Manual

TO mNSTALL MOWER
Follow procedure described in "INSTALL
MOWER AND DRIVE BELT" in the As-
sembly section of this manual. NOTE: You
will need to reattach front plate assembly
to tractor after sliding mower under the
tractor.
TO LEVEL MOWER HOUSING
Adjust the mower while tractor is parked
on level ground such as a carport or ga-
rage. Make sure tires are properly inflated
(See "PRODUCT SPECIFICATIONS"
section of this manual). If tires are over or
underinflated, you will not properly adjust
your mower.
SIDE-TO-SIDE ADJUSTMENT WITH
BUBBLE LEVEL
NOTE: If necessary, check side-to-side
surface below tractor for levelness with a
long board and the bubble level.
Using the lift lever, place mower in
position where no part of the mower,
including gauge wheels, is touching the
ground.
From left side of tractor, find the level
decal on top of mower and place bubble
level on decal as indicated.
Mower is level side-to-side when bubble
is between the two lines in the bubble
level.
If adjustment is necessary, under left
hand footrest, turn lift link adjustment
nut (above yellow cap) in appropriate
direction to bring bubble between the
lines in the bubble level.
Remove bubble level from mower and
store in a safe place.
Lift Link
Nut
ALTERNATE SIDE-TO-SIDE
ADJUSTMENT METHOD
Raise mower to its highest position.
Measure height from bottom edge of
mower to ground level at front corners
of mower. Distance "A" on both sides of
mower should be the same.
If adjustment is necessary, make adjust-
ment on one side of mower only.
To raise one side of mower, tighten lift
link adjustment nut on that side.
To lower one side of mower, loosen lift
link adjustment nut on that side.
NOTE: Each full turn of adjustment nut
will change mower height about 3/16".
Recheck measurements after adjusting.
Bottom Edge of Bottom Edge of
Mower to Ground Mower to Ground
FRONT=TO-BACK ADJUSTMENT
miViPORTANT: Deck must be level side=
to=side. If the following front=to=back
adjustment is necessary, be sure to adjust
both front links equally so mower will stay
level side-to-side.
To obtain the best cutting results, the
mower blades should be adjusted so the
front tip is approximately 1/8" to 1/2" lower
than the rear tip when the mower is in its
,_lghest position.
CAUTION: Blades are sharp. Protect
your hands with gloves and/or wrap blade
with heavy cloth.
Check adjustment on right side of tractor.
Position any blade so the tip is pointing
straight forward. Measure distance "B" at
front and rear tip of blade
,, Before making any necessary adjust=
merits, check that both front plate links
are equal in length.
If links are not equal in length, adjust
one link to same length as other link.
To lower front of blade, loosen nut "C"
on both front links an equal number of
turns.
NOTE: Each full turn of nut "C" will
change dim. "B" by approximately 3/16".
* When distance "B" is 1/8" to 1/2" lower
at front than rear, tighten nut "D" against
trunnion on both front links.
* To raise front of blade, loosen nut
"D" from trunnion on both front links.
24