Table of Contents
Advertisement
SERVICE AND ADJUSTMENTS
TO REPLACE
HEADLIGHT
BULB
•
Raise hood.
•
Pull bulb holder out of the hole in the backside of the
gdll.
•
Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill.
•
Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.
•
Check wiring.
See electrical wiring diagram in the
Repair Parts section of this manual.
TO REPLACE
FUSE
Replace with 30 amp automotive-type plug-in fuse. The
fuse holder is located behind the dash.
TO ADJUST
ATTACHMENT
LIFT SPRING
(See Fig. 35)
•
While holding spring bushing with wrench, loosen jam
nut.
•
Turn adjustment bolt clockwise to extend spdng and
reduce lift effort for heavier attachments.
•
Turn adjustment bolt counterclockwise
for lighter at-
tachments.
•
Retighten
jam nut against
spring bushing.
IMPORTANT:
DO NOT ADJUST
FOR MAXIMUM
SPRING
TENSION
WHEN
USING
LIGHT
ATTACHMENTS
SUCH
AS A MOWER.
ADJUST
LIFT LEVER SPRING TO AID IN
LIFTING ATTACHMENT.
DO NOT OVERPOWER
SPRING.
WHEN
REMOVING
ATTACHMENT,
ALWAYS
ADJUST
SPRING
TENSION
TO ITS LOWEST
POSITION.
ADJUSTMENT
SPRING BUSHING
ATrACHMENT
JAMNUT
LIFTSPRING
FIG. 35
TO
REMOVE
HOOD
AND
GRILL
ASSEMBLY
(See
Fig. 36)
•
Raise hood,
•
Unsnap headlight wire connector.
•
Stand in frontof tractor. Grasp hood at sides, tilt toward
engine and lift off of tractor.
•
To replace, reverse above procedures.
HOOD
HEADLIGHT
WIRE
CONNECTOR
FIG. 36
26
Advertisement
Table of Contents
