GE WNRD2050 Owner's Manual page 12

Before you call for service...
Troubleshooting -tips
Washer did not fill to
chosen level
(START/PAUSE lights
are flashing)
Waterfills anddrains
at thesametime
Possible Causes
Exlremely low water pressure
Inlet hoses axe kinked
Water valve screens axe
stopped up
Drain staald pipe is too low
What To Do
• Press tile STARTbutton again.
• Straighten hoses.
• WtlI'/1 of_
tile x_ter
SOtlrce }tll(1 relllove the
x_tei"
COllllectioll
hoses fl'om tile upper back of tile _;_she_: Use a brush or
toothpick to dean file screens in tile machine. Reconnect
tile hoses arid tuna file water back on,
• Drain stand pipe must be above 30".
Possible Causes What ToDo
Washeris noisy Washer is uneven
To level tile fl'ont of tile washe_; a(!iust tile fl'ont leveling
legs by rotating the individual leg in the proper direction
fl)r up or down. To level back of washe_; lift back of
machine 4" (11 cm) and set down.
Washer load is • Press PAUSEto stop tile washex; open tile lid and
unbalanced redistribute tile load evenly: Close tile lid and press
START.
Shipping rod is still assembled • To remoxe shii_ping rod from washex; pull yellow tag and
in unit attached _x)(1ti'om tile bottom right hand side of washe_:
Washer is sitting too close • Pull washer away fi'om the wall; about 4" (11 cm)
to wall (causes knocking is needed.
during cycle)
Labelsonthe exterior
of the washerwill not
pee! offcleanly
Possible Causes
Occasionally the adhesive
used on the labels does
not release clemfly
What ToDo
• Use a hair dryer set at tile lowest heat setting, directing
tile air at tile label fl)r a short amount _ff time. This will
release the adhesive easil> without damaging the s/m'iace
of tile washe_:
12