Craftsman 315.115820 Operator's Manual page 13

OPERATING THE CUT-OUT SAW
See Figure 8.
We suggest that you practice with the cut-out saw before
installing a bit and making cuts.
[] Hold cut-out saw firmly with both hands.
[] Start cut-out saw.
[] Tilt cut-out saw at a 45 ° angle.
[] Plunge bit into material using depth adjustment ring as
a pivot.
[] Raise cut-out saw slowly to a 90 ° angle.
[] Begin cutting.
ATTACHNNG CIRCLE CUTTER
See Figure 10.
[] Remove battery pack from cut-out saw.
[] Assemble circle cutter if necessary.
[] Remove bit if necessary.
[] Place adaptor under depth adjustment ring.
NOTE: Make sure the adaptor fits snugly.
[] Place circle cutter arm on top of depth adjustment ring.
[] Screw threaded ring onto adaptor, securing circle cutter
arm.
[] Insert bit.
Fig. 8
ASSEMBLNNG CIRCLE CUTTER
See Figure 9.
[] Remove battery pack from cut-out saw.
[] Attach handle with screw provided.
[] Attach pivot point knob with nut provided.
SCREW NUT
J CIRCLE
CUTTERARM
DEPTH
ADJUSTMENT
RING
ADAPTOR
THREADED
RING
Fig. 10
HANDLE
PIVOTPOINT
KNOB
Fig. 9
13