Table of Contents
Advertisement
,_,
WARNING:
To prevent accidental starting that
could cause serious personal injury, always remove
the battery pack from the tool when making adjust-
ments.
TO
LOOSEN
TO
LOOSEN
_
ADJUST UP
OR DOWN
Fig. 5
SELECTING
DEPTH
OF CUT
See Figure 5.
[] Remove battery pack from cut-out saw.
[] Loosen adjusting knob by turning counterclockwise.
[] Move depth adjustment ring to desired position.
[] Tighten adjusting knob by turning clockwise.
,_
WARNING:
Do not use router bits or any type of
cutter other than cut-out saw bits or drywall cutout
bits with this tool. This tool is not guarded for any
type of blade or cutter. The use of such cutters could
result in contact with the cutter and could cause
serious personal injury.
INSERTING/REMOVING
BITS
See Figure 6.
[] Remove battery pack from cut-out saw.
[] Depress spindle lock.
CAUTION:
To prevent damage to the spindle or
spindle lock, always allow motor to come to a
complete
stop before engaging spindle lock. Do
not start the cut-out
saw with the spindle
lock
engaged.
TIGHTEN'
Fig. 6
[] To insert bit: Insert shank end of bit into collet.
[] To remove bit: Remove bit once collet nut is loose.
NOTE: The 1/8 in. collet is machined to precision
tolerances to fit bits with 1/8 in. diameter shanks. To
use 1/4 in. shank bits, remove the 1/8 in. collet and
insert the 1/4 in. collet.
[] Tighten collet nut securely by turning clockwise with the
wrench provided.
,_IL WARNING:
if the collet nut is not securely tightened,
the bit may detach during use causing possible
serious personal injury.
[] Release spindle lock.
_
WARNING:
Do not use bits with undersized
shanks. Undersized shanks will not tighten properly
and could be thrown from the tool, causing injury.
STARTING/STOPPING
CUT-OUT
SAW
See Figure 7.
[] To start: Depress switch to the ON ( I ) position.
[] To stop: Depress switch to the OFF ( O ) position.
_
WARNING:
Battery tools are always in operating
condition. Therefore, switch should always be in the
off position when not in use or carrying at your side.
[] Loosen collet nut by turning counterclockwise
with the
wrench provided.
,_
WARNtNG:
If you are changing a bit immediately
after use, be careful not to touch the bit or collet
with your hands or fingers. They will get burned
because of the heat buildup from cutting.
Always use the wrench provided.
ON
AUXILIARY
HANDLE
CAP/SLOT
Fig. 7
12
Advertisement
Table of Contents
