Download Print this page

Craftsman EZ3 917.256711 Owner's Manual page 16

Advertisement

OPERATION
MOWING
TIPS
MULCHING
MOWING
TIPS
Tire chains cannot be used when the mower housing
is attached to tractor.
Mower should be properly leveled for best mowing
performance.
See'q-O LEVEL MOWER HOUSING" in
the Service and Adjustments section of this manual.
The ieft hand side of mower should be used for trim-
ming.
Drive so that clippings are discharged onto the area
that has been cut. Have the cut area to the right of the
machine. This will result in a more even distribution of
clippings and more uniform cutting.
When mowing large areas, start by turning to the right
so that clippings
will discharge
away from shrubs,
fences, driveways, etc. After one ortwo rounds, mow
in the opposite direction making left hand turns until
finished (See Fig. 12 ).
If grass is extremely tall, it should be mowed twice to
reduce load and possible fire hazard from dried clip-
pings. Make first cut relatively high; the second to the
desired height,
Do not mow grass when it is wet. Wet grass will plug
mower and leave undesirable clumps.
Allow grass to
dry before mowing.
Always operate engine at full throttle when mowing to
assure better mowing performance
and proper dis-
charge of material.
Regulate ground speed by select-
ing a low enough
gear to give the mower cutting
performance
as well as the quality of cut desired,
When operating attachments,
select a ground speed
that will suit the terrain and give best performance
of
the attachment being used.
F
1
f
C----
<
J
FIG. 12
IMPORTANT:
FOR
BEST
PERFORMANCE,
KEEP
MOWER
HOUSING
FREE
OF BUILT-UP
GRASS
AND
TRASH,
CLEAN
AFTER
EACH USE.
The special mulching blade will recut the grass clip-
pings many times and reduce them in size so that as
they fall onto the lawn they will disperse into the grass
and not be noticed.
Also, the mulched
grass will
biodegrade
quickly to provide nutrients for the lawn.
Always mulch with .your highest engine (blade) speed
as this will provide the best _recutting
action of the
blades.
Avoid cutting your lawn when it is wet. Wet grass tends
to form clumps and interferes with the mulching action.
The best time to mow your lawn is the early afternoon.
At this time the grass has dried and the newly cut area
will not be exposed to the direct sun.
For best results, adjustthe mower cutting height so that
the mower cuts off only the top one-third of the grass
blades (See Fig. 13). For extremely heavy mulching,
red uce you r width of cut on each pass and mow slowly.
Certain types of grass and grass conditions
may re-
quire that an area be mulched a second time to com-
pletely hide the clippings.
When doing a second cut,
mow across or perpendicular to the first cut path.
Change your cutting pattern from week to week. Mow
north to south one week then change to east to west the
next week. This will help prevent matting and graining
of the lawn.
MAX 1/3
I
l
FIG. 13
16

Advertisement

loading