Unpackthe Pressure Washer; Carton Contents - Craftsman 580.752100 Operator's Manual

Your c leaning system requires some assembIy andisready
foruse onlyafter i t hasbeen properiy serviced withthe
recommended oilandfuel.
Jf
you have any prohbms with the assembly of your
pressurewasher, please call the pressurewasher hempline
at 1o800o222o3136.
UNPACKTHE PRESSURE WASHER
1. Remove everything from carton except pressure washer.
2. Open carton completely by cutting each corner from top
to bottom.
3. Remove pressure washer from carton.
CARTONCONTENTS
Checkali contents, if any parts are missing or damaged, call
the pressure washer hetpline at 1=800=222=3136.
° Main Unit
* Handb with CieaningTank Assembly
, Accessory Tray
° High Pressure Hose
° Spray Gun
, PrecisionSpray
TM
Selector
, DetergentSiphoning Hose/Fiiter
*
Oil Bottle
, Parts Bag (which includes the following):
.
Operator's Manual
, Owner's Registration Card
, Safety Goggies
, HandieFasteningHardwareKit (which includes):
, Carriage Bolts (2)
, Plastic Knobs (2)
, Tree 6iips (4)
Becomefamiiiar with each piece before assembiing the
pressure washer. Identify alI contents with the illustration on
page 6. if any parts are missing or damaged, call the
pressure washer helptine at 1-808-222-3136.
A$$EJ IBLING CLEANING SYSTEJ
Your Craftsman cleaning system will need assembly before
operation:
1. Fiii out and send in registration card.
2. Attach handie and accessory tray.
3. Connect detergent siphon hose to pump.
4. Add eli to engine crankcase.
5. Add fuel to fuel tank.
6. Connect pressure hose to spray gun and pump.
7. Connect water supply to pump.
8. Attach PrecisionSpray
TM
Selector to spray gun.
Attach Handle and Accessery Tray
1. Placehandb (A) onto handb supports (8) connected to
main unit. Make sure holes (C) in handb align with holes
(C) on handle supports.
NOTE:it may be necessary to move the handle supports
from side to side in order to align the handle so it wifl slide
over the handIesupports.
2. Insert carriage bolts (A) through holes from back of unit
and attach a plastic knob (8) from front of unit. Tighten
by hand.
3. Placeaccessory tray (A) over holes (g) on handle
(viewing from front of unit). Push the tree clips (8) into
the holes until they sit fiat against the accessory tray.
/
/
/
Insert supplied accessories in spaces provided in
accessory tray. See How to Use Accessofy Tray.