Attach Handle And Accessory Tray; Unpackthe Pressure Washer; Carton Contents - Craftsman 580.752242 Operator's Manual

Your pressure washer requires some assembly and is ready
for use only after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
pressurewasher, please call the pressurewasher helpline
at 1-800-222-3136.
UNPACKTHE PRESSURE WASHER
1. Remove everything from carton except pressure washer.
2. Open carton completely by cutting each corner from top
to bottom.
3. Remove pressure washer from carton.
CARTONCONTENTS
Check all contents. If any parts are missing or damaged, call
the pressure washer helpline at 1-800-222-3136.
• Main Unit
• Handle
• Accessory Tray
• High Pressure Hose
• Spray Gun
• Spray Tip Extension with Quick Connect Fitting
• Oil Bottle
• Parts Bag (which includes the following):
• Operator's Manual
• Owner's Registration Card
• Bag containing 3 multi-colored Spray Tips
• HandleFasteningHardwareKit (which includes):
• Carriage Bolts (2)
• Plastic Knobs (2)
• Tree Clips (4)
Become familiar with each piece before assembling the
pressure washer. Identify all contents with the illustration on
page 6. If any parts are missing or damaged, call the
pressure washer helpline at 1-800-222-3136.
ASSEMBLING PRESSURE WASHER
Your Craftsman pressure washer will need assembly before
operation:
1. Fill out and send in registration card.
2. Attach handle and accessory tray.
3. Add oil to engine crankcase.
4. Add fuel to fuel tank.
5. Connect pressure hose to spray gun and pump.
6. Connect water supply to pump.
7. Attach spray tip extension to spray gun.
8. Select/attach quick connect spray tip to spray tip
extension.
Attach Handle and Accessory Tray
1. Place handle (A) onto handle supports (B) connected to
main unit. Make sure holes in handle align with holes on
handle supports.
NOTE:It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
2. Insert carriage bolts (6) through holes from inside of
unit and attach a plastic knob (D) from outside of unit.
Tighten by hand.
3. Placeaccessory tray (E) over holes (F) on handle
(viewing from front of unit). Push the tree clips (G) into
the holes until they sit flat against the accessory tray.
/
4. Insert multi-colored Quick Connect spray tips and other
supplied accessories in spaces provided in accessory
tray. See How to Use Accessory Tray.